reece 101 service
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
S-<strong>101</strong><br />
CORD TRIM - MACHINE ADJUSTMENT<br />
THREAD TRIMMER AND THREAD RETAINER<br />
Upper thread trimmer is activated by a wedge located on the main cam. Movement of the thread<br />
trimmer should be delayed as late as possible to allow thread pick up hook to be in position, to<br />
pick up trimmed thread.<br />
Knife should be set to clear front of needle and bottom of throat plate. Also check that knife<br />
clears top of spreader.<br />
Knife should be installed and adjusted so that it trims thread on the return strock.<br />
Thread retainer should be set below the top<br />
surface of the throat plate and set lightly<br />
against the front of the throat plate. Thread<br />
retainer in its home position should be to<br />
the right of the thread slot. When the<br />
trimmer is activated thread retainer wipes<br />
across the thread slot and captures thread<br />
for the next cycle.<br />
<br />
<br />
<br />
<br />
<br />
The check spring on the top of the race is<br />
adjustable as to swing out and in, loosen<br />
screw and adjust the stop wire .<br />
The approx. correct position is as shown in<br />
Figure 3 at (X) (at edge of machined portion<br />
if cam case)<br />
<br />
<br />
<br />
TO SET THE UNDER THREAD GUIDE<br />
Adjust the under thread guide so that thread lies<br />
close to the under side of the looper and thread runs<br />
freely without friction - use screw to adjust.<br />
1-26<br />
Revised 09/2004<br />
e-mail: <strong>service</strong>@amf<strong>reece</strong>.cz; parts@amf<strong>reece</strong>.cz; website: www.amf<strong>reece</strong>.com<br />
Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606