A family-run firm from Austria with a workforce of 220 employees, KATZBECK has manufactured bespoke windows and doors made of wood and wood/aluminium for over 65 years. KATZBECK products stand for first-rate design, innovation, outstanding quality and green production processes. KATZBECK is your competent and capable partner in all stages of door and window production, from consulting and planning, to manufacture and installation. Open your senses and find inspiration for your home. Select from a broad range of models, colours and forms; create precisely the atmosphere in your ‘four walls’ that best suits your style. Visit our headquarters and production facility in Rudersdorf or one of our eight window studios in Austria.
4) Lifting leaf out: 4) Flügel herausheben: 20. Adjustment of Fittings of Lifting-Sliding-Doors In the course of assembly it is important to mount the threshold and/or the vertical frame in a way as to ensure that the distance between the leaf and the frame runs parallel so proper closing and locking can be guaranteed, as the rails can not be fitted with an adjustment mechanism. Therefore, the leaf must be mounted to ensure proper closing before the frame and threshold are braced. It is possible to adjust the contact pressure of the leaf via adjustable hasps (milled into the frame) (see drawing to the right). 36 KATZBECK-MANUAL
21. Operating and Adjusting Front Doors Only authorized licensed professionals are permitted to perform the remounting and unhinging, as well as adjusting the fittings! The following front door systems features the BAKA Protect 4040 3D FD door hinge:: Doors opening to the inside of the following systems: MASSIVA, SIDE DOORS, LUMA, DESIGN, COMBINA, ALUMA. Doors opening to the outside of the following systems: MASSIVA, SIDE DOORS, MASSIVA, LUMA. Arrangement of hinges for 3 hinges: Bandanordnung bei 3 Bändern: Lateral adjustment 140 210 140 210 Lateral Turn both adjustment screws equally (max. one turn) in relevant direction. Avoid tilt knuckles and tension on the axis. Proper alignment is crucial! Lateral Height adjustment 270 140 Arrangement of hinges for 4 hinges: Bandanordnung bei 4 Bändern: 140 210 140 210 Locking screw Height adjustment Locking screw Slightly loosen the clamping screws in the frame part of all hinges. Adjust the height by turning the eccentric adjustments of the middle hinge in desired direction. Retighten the clamping screws. Compression adjustment 140 210 270 140 Locking screw Adjustment of contact pressure Locking screw Slightly loosen the clamping screws in the frame part of all hinges. Adjust the compression by turning the eccentric adjustments of the upper and the lower hinge in the desired direction. Retighten the clamping screws. When a fourth front door hinge is used it is assembled as a “neutral center hinge”. It does not feature any possibilities of adjustment. Loosen the locating screws before adjusting the other hinges, above hinge will easily move to adjust along with the others. After adjustment has been completed, this hinge also needs to be re-fixed via the locating screw. KATZBECK-MANUAL 37