EPPxxxx | EtherCAT P Box (industrial housing) www.beckhoff.com/EPPxxxx EtherCAT Box 294 Signal status EtherCAT P output EtherCAT P input Signal status display Robust housing for industrial application Standard labels Watertight and dust-proof, due to protection class IP 65 / 66 / 67 (fully potted) Connection of sensors/ actuators via connector: – M8, screw type – M12, screw type Ultra compact dimensions (H x W x D) 126 x 30 x 26.5 mm Power supply status display: box supply and auxiliary voltage eXtreme Fast Control Technology +60 °C -25 °C Extended operating/ storage temperature Extended mechanical load Mounting holes We reserve the right to make technical changes.
I/O connections 8 x M8, 4 x M12 (126 x 30 x 26.5 mm) 16 x M8, 8 x M12 (126 x 60 x 26.5 mm) Ground contact Connector M8, screw type, 3-pin Connector M12, screw type, 5-pin EtherCAT Box 295 EtherCAT P combines communication and power in a single 4-wire standard Ethernet cable. The 24 V DC supply of the EtherCAT P slaves and of the connected sensors and actuators is integrated: US (system and sensor supply) and UP (peripheral voltage for actuators) are electrically isolated from each other and can each supply a current of up to 3 A to the connected components. The EPPxxxx EtherCAT P modules in protection class IP 67 cover the typical range of requirements for I/O signals: digital inputs (3.0 ms or 10 μs filter), digital outputs with 0.5 A output current, combination modules with digital inputs and outputs, analog inputs and outputs with 16-bit resolution, thermocouple and RTD inputs. The EPP13xx EtherCAT P junctions are available for flexible topology configuration. The current carrying capacity of 3 A per EtherCAT P segment already enables a wide range of sensors/actuators to be used. If a power supply boost is required, the EPP1332-0001 EtherCAT P junction can be used to feed in both US and UP at any point. The EPP1342-0001 should be used for branches without voltage boost. Further information on EtherCAT P see page 46 EPPxxxx-00yz 0 = no connectors 1 = connector M8, screw type, 3-pin 2 = connector M12, screw type, 5-pin 3 = special connectors 4 = connector M16, screw type, 19-pin 8 = D-sub, 25-pin 10 = 2 x D-sub, 9-pin 11 = D-sub, 15-pin 0 = width: 30 mm 2 = width: 60 mm 4 = pressure inputs 6 = height: 86 mm Signals see page 296 We reserve the right to make technical changes.