Views
2 months ago

V27 Software Guide Pulpmatic Ultima Eco Uno Incomatic V1.7

11. Amending the

11. Amending the parameter settings There are three types of control PCB’s used across the range of macerators. Type A 60-24-177 Type B 60-24-068 Type C UNO2031 Standard 110v PCB Universal PCB Low Voltage PCB 11.1 PCB Type C The following will describe the process of putting each machine type into a programming mode and the correct sequence to change each of the parameters. A detailed guide to the functionality of the parameters and a list of the current settings is also provided for each machine type. Dip Switch 1 • Move DIP switch 1 into the ON position • A0 will appear in the display • Press button SW4 – A1 will appear in the display • Press button SW4 – A2 will appear in the display • Continue to press SW4 until the correct parameter appears on the display • Press SW3 to view the current setting • Press SW1 to increase the setting • Press SW5 to decrease the setting SW4 SW3 • When programming is complete move DIP switch 1 up, into OFF position • Press SW4 once to reset the machine for new parameters to take effect SW2 SW1 SW5 Copyright © 2017 DDC Dolphin Ltd. Page 24 of 47 February 18 SGPv27 – V1.7

11.2 PCB Type A & B SW2 SW1 SW4 SW3 • Move DIP Switch 1 "ON" (Up) • A0 will appear in the display • Press button SW2 – A1 will appear in the display • Press SW1 to view the current START sensor sensitivity setting • Press SW3 to increase the sensitivity of the Dip Switch 1 • Press SW4 to decrease the sensitivity of the START sensor • The maximum setting is 99, the optimum setting is 80 - 85 • Adjust the PCB settings and test the START sensor sensitivity • When calibration is complete move DIP switch 1 “OFF” (down position) Copyright © 2017 DDC Dolphin Ltd. Page 25 of 47 February 18 SGPv27 – V1.7

A Leader's Guide to Agile Business - Rally Software
Polycom UC Software 4.0.1 Administrators' Guide
Platinum Software User Guide. - Dating Software
Polycom UC Software Administrators' Guide
JideFX Common Layer Developer Guide - JIDE Software
Polycom UC Software Administrators' Guide - 4.1.0
User Guide for Alliance Planner Programming Software - UniMac
WinTEC3 Software user's Guide - Electromotive Engine Controls
Photo/Graphic Edges 5.0 Evaluation Guide - Auto FX Software
Nesting Product Comparison Guide (PDF) - Hypertherm CAM Software
EA Connector for Trac Feature Guide - SparxSystems Software GmbH
clouding software template user guide - Magento extensions