9 months ago

V27 Software Guide Pulpmatic Ultima Eco Uno Incomatic V1.7

When you are satisfied

When you are satisfied that the new software has been accepted and installed onto the PCB, go to next step Step 12: Turn the machine and laptop OFF and disconnect the USB cable Step 13: Turn the machine back on and reset the board by pressing and holding the reset button for 10 seconds. The reset button location for each model is detailed below: Type A & B: Type C: Hold down button SW2 Hold down button SW4 (Fig 19) (Fig 20) Step 14: Verify the correct operation of the machine by performing 2 or 3 cycles to ensure the unit is operating to the required standard. Step 15: Please rescan the PCB to confirm the new software version is displayed and working by repeating the process shown in Section 14 SW2 SW4 (Fig 19 – Type A & B) (Fig 20 – Type C) Copyright © 2017 DDC Dolphin Ltd. Page 34 of 47 February 18 SGPv27 – V1.7

15. How to put the machine into exhibition mode DDC Dolphin manufactures a range of lightweight semi functional exhibition machines. In addition any DDC Dolphin machine with an automatic lid can be used as a demonstration unit for exhibitions or client demonstrations. Adjustments to the control circuit will temporarily turn a fully functional machine into a semi functional demonstration unit. There are two types of exhibition mode, an automatic mode and a mode that requires user input. In exhibition mode the water pump and cutting motor are disabled, the lid motor and hands free sensor are operational Please note these modifications must be carried out by a competent person! Automatic exhibition mode Automatic mode allows the machine to continuously cycle opening and closing of the lid. The lid will close and the display will countdown from 10 seconds to zero then opens the lid and waits for an additional 10 seconds before repeating the whole process. Manual exhibition mode Manual mode requires the user to activate the machine using the foot cup sensor which will open the lid. Activating the hands free sensor will then close the lid and the display will countdown from 10 to zero. The user then has to operate the foot cup sensor to open the lid. Disable the water valve Please note that the float switch and the water valve remain active. To prevent damaging the water inlet valve, you MUST remove the rear access plate below the rear of the lid. The float switch in the water tank MUST be tied up in the off position. This will close the water input valve (not applicable to exhibition build machines). Please remove this feature when you have taken the machine out of exhibition mode. Copyright © 2017 DDC Dolphin Ltd. Page 35 of 47 February 18 SGPv27 – V1.7

A Leader's Guide to Agile Business - Rally Software
Medical Office Software Guide
WinAlign® Software
License Administration Guide - Sonnet Software
Agile Development, DevOps and achieving ... - Rally Software
Geovision NVR Software Feature Guide - Use-IP
Product datasheet: Sony SNC-DH240T - Network Webcams
EtherLogic Ultima Controller - Industrial Control Links
JideFX Common Layer Developer Guide - JIDE Software
Polycom UC Software 4.0.1 Administrators' Guide
Polycom UC Software Administrators' Guide
Platinum Software User Guide. - Dating Software
EA Connector for Trac Feature Guide - SparxSystems Software GmbH
Polycom UC Software Administrators' Guide - 4.1.0
Island of the Blue Dolphins - challenge - Merit Software
Photo/Graphic Edges 5.0 Evaluation Guide - Auto FX Software