Views
7 months ago

V27 Software Guide Pulpmatic Ultima Eco Uno Incomatic V1.7

3. Cautionary notes

3. Cautionary notes Failure to comply with the instructions and recommendations contained within this guide may impair the safe operation and reliability of the machine. It may also invalidate the warranty of the Pulpmatic unit. This machine should only be used for the purpose for which it was designed. Only maceratable friendly products should be placed into the chamber. Caution rotating blade inside lower chamber. Caution, when handling the detergent chemicals used by the machine, it is recommended that PPE is worn such as gloves and eye protection to prevent contact with skin and eyes. Only use chemicals or detergents supplied or approved by DDC Dolphin Ltd. DO NOT place plastic, metal or any other non maceratable objects into the chamber. DO NOT start the machine until it has been commissioned by a trained DDC Dolphin Ltd agent. If the machine is started without commissioning, this will damage the machine and invalidate the warranty. DO NOT obstruct the movement of the lid or place anything around the top of the chamber to prevent the lid closing. Always isolate the electrical supply to the machine before opening the front panel IMPORTANT The hands free IR (Infra-red) sensor must be calibrated before the machine is used by the client (Parameter A1) Copyright © 2017 DDC Dolphin Ltd. Page 4 of 47 February 18 SGPv27 – V1.7

4. Release notes Revision Notes Suitable for V11 Revised PCB to include cutter current motor monitoring to provide more accurate measurement off overload applied to the cutting machine Ultima, Uno, Pulp+ & Eco V12 & V13 Never released N/A V14 Update for Australian Market only – Temperature and time setting. N/A (Panamatic’s Only!) V15 Change from motorised locks to Southco locks Ultima, Uno, Pulp+ & Eco V15.2 (Eco only) Eco only – first release Eco V16 Never released V17 Patlite audio system included, new lid open close time settings, 5 second delay introduced to water solenoid when float switch first activates to compensate for high water pressure environments. Function to auto start the machine from foot cup activation only. (Machine start option parameter) Ultima, Uno, Pulp+ & Eco V18 & V19 Never released V20 New model 3 Phase Uno added. Mid-cycle dosing from chemical pump introduced Ultima, Uno, Pulp+ & Eco V21 Wiring configuration for the IMO motor drive unit (Uno only!) IMO unit is now powered down until the machines goes into cycle Ultima, Uno, Pulp+ & Eco V22 New feature added to enable hands free start if water tank not full. Lid will close and machine will start automatically once water tank has completed filling Corrections & enhancements to A2 start options Ultima, Uno, Pulp+ & Eco Copyright © 2017 DDC Dolphin Ltd. Page 5 of 47 February 18 SGPv27 – V1.7

A Leader's Guide to Agile Business - Rally Software
Medical Office Software Guide
WinAlign® Software
Estimation of Source Parameters for Hazard Releases
SNC-DH110T - Sony Professional Solutions Asia Pacific
License Administration Guide - Sonnet Software
Agile Development, DevOps and achieving ... - Rally Software
Geovision NVR Software Feature Guide - Use-IP
Product datasheet: Sony SNC-DH240T - Network Webcams
Ultima SmartBelt User Guide
EtherLogic Ultima Controller - Industrial Control Links
JideFX Common Layer Developer Guide - JIDE Software
Polycom UC Software Administrators' Guide