Step 4: Clean both wipers one by one with the help of wet cleaning stick, as shown below: Fig 105: Cleaning the Wiper Step 5: After completing the wiper cleaning, press the ENTER button from the Control Panel of the print engine. The CLOSE COVER R screen appears, as shown below: Step 6: Close the right cover, as shown below: Fig 106: Displaying the Close Cover R Screen Now, wipers get cleaned. Fig 107: Closing the Cover TXF Page | 56
Cleaning the Surrounding Area of Print Head Follow these steps to clean the surrounding area of Print Head: Step 1: Set the Manual Cleaning mode by performing all the steps mentioned in the Setting Manual Cleaning Mode section. Step 2: Press the Up or Down arrow and select the OPEN COVER L option. Step 3: Press the ENTER button from the Control Panel of the print engine. Step 4: Open the left cover to clean the surrounding area of the Print Head, as shown below: Fig 108: Removing the Left Cover As per the given instruction on the screen, the following screen appears, as shown below: Fig 109: Displaying the Instruction to Remove Cut Rail Step 5: Remove the bolt and Cut Rail, as shown below: Fig 110: Removing the Bolt (1) and Cut Rail (2) Step 6: Press the ENTER button from the Control Panel of the print engine to move to the next step. Step 7: Open the right cover. Step 8: Wet the cleaning stick with the cleaning liquid. TXF Page | 57
USER MANUAL India’s largest manuf
Table of Contents 1. About Document
Monthly Maintenance ...............