Views
8 months ago

sppe-catalogue-final_2017-2018

Respiratory Protection

Respiratory Protection Introduction Assess the Risk: Application limits for reusable half and full face masks Filter Classification NPF* with Half Mask NPF* with Full Face Mask P1 4 x OEL 5 x OEL P2 10 x OEL 10 x OEL P3 50 x OEL 200*** x OEL Class 1 Gas and Vapour filters 10 x OEL or 1000ppm (whichever is lower) 200*** x OEL or 1000ppm (whichever is lower) Class 2 Gas and Vapour filters 10 x OEL or 1000ppm (whichever is lower) 200*** x OEL or 5000ppm (whichever is lower) AX-Filter for low boiling point (organic composition with a low boiling point under 65 O C). A1 and A2 Filters for organic vapour with a boiling point above 65 O C. * Country APF should be used where available. NPF = Nominal Protection Factor ** OEL please use local exposure limit. OEL = Occupational Exposure Limit *** Not the NPF. ppm = parts per million Select the Correct Respirator Which of these characteristics does your potential respirator have? • Durable • Maintenance-free • Ready to use • Comfortable • Lightweight • Easy to fit • Adjustable head bands • Drop Down Feature • Easy to clean • Quick de-assembly for maintenance • Modular replacement filter system • Variety of filters • Eye Protection • Six-point head harness • Speaking diaphragm • Spare parts • Accessories • Multiple sizes available • Colour coded sizes www.selectppe.co.za 55

Introduction Respiratory Protection Fitting Instructions 1. Cup the respirator in your hand with the nose piece at your fingertips allowing the headbands to hang freely below your hand. 2. Position the respirator under your chin with the nose piece up. 3. Pull the top strap over your head resting it high at the top back of your head. Pull the bottom strap over your head and position it around the neck below the ears. 4. Place the fingertips of both hands at the top of the metal nose piece. Mould the nose piece to the shape of your nose by pushing inward while moving your fingertips down both sides of the nose piece. Pinching the nose piece using one hand may result in less effective respirator performance. 5. The seal of the respirator on the face should be fit-checked prior to wearing in the work area. A) Cover the front of the respirator with both hands, being careful not to disturb the position of respirator. B) Inhale sharply. A negative pressure should be felt inside the respirator. If any leakage is detected, adjust position of respirator and/ or tension of strap. Retest the seal. Repeat the procedure until the respirator is sealed properly. Respiratory protection is only effective if it is correctly selected, fitted and worn throughout the time when the wearer is exposed to hazards. Note - do not use with beards or other facial hair that may inhibit contact between the face and the edge of the respirator. 56 Select PPE Protecting People Everyday

Soluxio product catalogue 2018
Fall 2018 Catalogue
Kawada Australia 2018 Catalogue
RUKUevent Catalogue pavilions - 2018
watersports-catalogue-boatworld-2018
KC HiLiTES catalogue 2018
medical devices catalogue 2018