2 weeks ago

Getting Started


5 • THE ADVANCED TRANSFER PANEL Prompt Accumulation Length Initial Status Report Statistics Description The accumulation length of the entity. This size is utilized in the simulation only when the conveyor type is Accumulating. Initial status of the conveyor, either Active or Inactive. Specifies whether or not statistics will be collected automatically. Segment module DESCRIPTION The Segment module defines the distance between two stations in the segment set of a conveyor. The beginning station, ending station, and segment are used to create the appropriate segment set, which defines the path of the conveyor. Typically, more than one Segment module is used to define the segment set. TYPICAL USES • Distillery operation that has a path from bottling to labeling to the boxing area • Baggage-handling area that has a path from check-in to a holding area to a staging area PROMPTS Prompt Name Beginning Station Next Station Length Description Name of the segment. The name of the first station that is located on the conveyor. The name of the next station that is located on the conveyor. Distance between this station and the previous station. 103

GETTING STARTED WITH ARENA Transporter module DESCRIPTION The Transporter module allows the definition of a free-path or guided transporter device for entity movement from one location to another. Free-path transporters move freely between stations and are not influenced by other transporter traffic. The Distance module specifies the distances between stations. Guided transporters, on the other hand, are restricted to run on fixed paths such as tracks or rails. Movement may be affected by traffic congestion from other vehicles. Guided transporters travel on networks defined using the Network and Network Link modules. Each spreadsheet entry creates a single transporter set. When using a transporter to transfer between modules or as the server in a Leave or Enter module, the transporter must be defined using the Transporter module. TYPICAL USES • Forklifts that transfer parts between processing stations • Wheelchairs that move patients between diagnostic areas PROMPTS Prompt Name Number of Units Type Distance Set Network Name Velocity Units Description Name of the transporter. Can be used to represent a set of multiple transporter units; each unit within the set is capable of independent movement. Number of independent transporter units in the transporter set. Specifies whether the transporter set is free path or guided. Specifies the name of the distance set that contains the station names and distances between which the free path transporter will travel. Distances are defined in the Distance module. Specifies the name of the network that defines the distances and zone configuration of all paths that the guided transporter set may follow. Networks are defined in the Network module and the links/segments that make up a network are defined using the Network Link module. The initial velocity of the set of transporter units in length units per base time unit. Velocity time units. 104

Getting Started Guide
Getting Started Guide
LTspice IV Getting Started Guide
98-375 BrainDumps Discount
getting started with eventstudio -
SonicWALL EX9000 Getting Started Guide - Ingram Micro
Telit Getting Started Guide -
Blueback Project Tracker Getting Started Guide - Ocean
PXI and PCI Getting Started - Egmont Instruments
Presentation slides [PDF] - Joint Steering Committee for ...
Getting Started - Ramsey County Parks and Recreation
Logistics MBA. Get Started. - Institute for Defense & Business
TransienT immuniTy simulaTors For ConDuCTeD DisTurBanCes
Painting Getting Started Craft Sheet - Play Resource
School Wellness Policy Getting Started - Connecticut State ...
M70-101 Latest Exam BrainDumps
The Terraform Book
4g pa design gets help 4g pa design gets help - AWR Corporation
MAGS-COA: Using MAGS to support scenario assessment and critic ...
Arena Material: chapter 5 - AS Nida