Views
8 months ago

CAPITOL TECHNICAL GUIDE v3

TRACK LOCATIONS –

TRACK LOCATIONS – BIFOLD OUTSIDE MOUNT OPUS POLYMER ENCORE INSIDE & OUTSIDE (if boards ordered) 134mm 139mm 115mm 115mm 50mm 30mm 50mm 30mm 140mm 150mm 77mm 58mm 82mm 58mm 20mm 10mm 29mm 48mm 85mm 30mm 85mm 30mm 115mm 115mm 40

INSIDE MOUNT TRACK BYPASS / SLIDING Headboards are supplied as standard for track bypass / sliding panels with top track attached. Sideboards and bottom boards are optional however floor track is mandatory with no option to waive warranty. It is not often a recess is deep enough to accommodate the entire headboard so sideboards are recommended to provide better light block. Standard deductions are taken at the factory for inside mount, however if a part inside mount is required with shorter returns, you must specify this in notes. Ensure there is enough clearance for doorhandles, track layouts are specified on the next page. 1. Measure the recess depth 2. Measure the diagonal to check for squareness. If the diagonal sizes vary by more than 10mm, an outside mount is preferable 3. Measure inside width in at least 3 places (top, centre and bottom) 4. Provide the smallest width size as window size, do NOT take a deduction 5. Measure inside height in at least 3 places (left, centre and right) 6. Provide the smallest height size as window size, do NOT take a deduction 7. If a divider rail is required, measure from the inside bottom to the centre of the required divider rail location. Remember rails could vary up to 40mm if not specified critical. OUTSIDE MOUNT TRACK BYPASS / SLIDING Headboards are supplied as standard for track bypass / sliding panels with top track attached. Sideboards and bottom boards are optional however sideboards are recommended for outside mount to provide better light block. It is common practice to mount headboard and sideboards outside of the architrave hard up against the wall. For this layout, you will need to add extra to your sizes to allow for boards. Ensure there is enough clearance for doorhandles. Track layouts are specified on the next page. 1. Measure outside of architrave width in at least 3 places (top, centre and bottom) 2. Add at least 38mm for sideboards (if required) as finish size 3. Measure outside of architrave height in at least 3 places (left, centre and right) 4. Add at least 19mm for headboard as finish size 5. If a divider rail is required, measure from the floor or outside of architrave to the centre of the required divider rail location. Remember rails could vary up to 40mm if not specified critical. 41

WorkEngine v3.x Installation Guide - EPM Live
TECHNICAL GUIDE
CAPITOL CORRIDOR
Capitol Capitol - Minnesota's Private Colleges
TECHNICAL GUIDE
TECHNICAL GUIDE
HL7 V3 TECHNICAL EDITING: RIM INTRODUCTION - HL7 Wiki
Technical Guide - RM.com
Technical Guide - Hyster Company
Technical Guide - Hyster Company
Waspmote: Technical Guide - Libelium
Racor Products Technical Guide
2015-additional-needs-guide-v3
Capitol Celebrates 80 Years! - Capitol College
LO5.0T Technical Guide - Hyster Company
Brochure / Technical Guide - Hyster Company
Technical Guide - Antietam Velo Club
HyPURITY HPLC Technical Guide - Chromatopak
Technical & Parts Guide - Wilwood Engineering
Brochure / Technical Guide - Hyster Company