Views
2 weeks ago

5100512174-03

t l Operation 3 1 Press

t l Operation 3 1 Press the key to run the self-test: 2 The display lights up for a few seconds DB124949 3 The indicators light up for a few seconds 4 Identification of channels connected to toroids 5 Pre-alarm and alarm tripping in "on" mode pre-al. alarm 1 2 3 4 5 6 7 8 9 10 11 12 6 "rSt" flashes if the test result is OK. b Press the Test key twice to return to default display. Reset t l I %(I al.) max I pre-al. t pre-al. (s) I alarm "on" = trip t alarm (s) "off" = no trip Modif mA A DB124948 pre-al. alarm Test Reset 1 2 3 4 5 6 7 8 9 10 11 12 I %(I al.) max A mA I pre-al. t pre-al. (s) I alarm "on" = trip t alarm (s) "off" = no trip Modif Test Reset 5100512174-03 Released for Manufacturing Printed on 2013/01/09 65/69

Operation DB124950 Communicating via the internal bus Introduction The Vigirex RMH may be connected to the Digipact electrical installation management system. The Vigirex RMH can then communicate with a supervisor via the Digipact DC150 data concentrator. This allows remote viewing of b Measurements. b Vigirex RMH status. b Settings. It is also possible to modify settings remotely. Types of communication Data may be transferred: b in real time b periodically b on request. Please note: a complete description of the types of communication and the protocol used is available in the literature on the DC150 data concentrator. Identification on the network Number of points occupied by the Vigirex RMH: 24 points. Automatic addressing: see Digipact DC150 data concentrator manual. Number of Vigirex RMH that can be connected to the Digipact DC150 data concentrator: 4. 5100512174-03 Note : b if the RMH is in measurement mode (I, %I al., I max), "Adr" mode can be accessed by pressing the Modif (I, % I al., I max) Released for Manufacturing Printed on 2013/01/09 b to exit "Adr" mode, press the . 66/69

n°03
n°03
Modern 03
Program_-Guide_2015-03-03
NEWS 03
feineadressen_berlinpotsdam_2015-03