Views
6 months ago

CAPITOL TECHNICAL MANUAL

OUTSIDE MOUNT 90º

OUTSIDE MOUNT 90º CORNER WINDOW 1. Measure outside from the architrave to the back of where the frame would sit, at the front edge of the window as shown left. 2. A+B = total window width. 3. This is the size you enter on the order as finish size 4. The total width of A is the location of corner post 5. If a divider rail is required, measure from the floor or outside of architrave to the centre of the required divider rail location. Remember rails could vary up to 40mm if not specified critical. 6. If a T post is required, measure from the outside of architrave at left to the centre of the T post 7. T post location in area B would be A + Post position INSIDE MOUNT TRACK BIFOLDS Headboards are supplied as standard for track bifolds with top track attached. Sideboards and bottom boards are optional however floor track is mandatory with no option to waive warranty. Track bifolds can be installed inside mount and standard deductions are taken at the factory to allow for fitting. If semi recess mount is required with shorter returns, you must specify this in notes. Ensure there is enough clearance for doorhandles, track layouts are specified on the next page. 1. Measure the recess depth 2. Measure the diagonal to check for squareness. If the diagonal sizes vary by more than 10mm, an outside mount is preferable 3. Measure inside width in at least 3 places (top, centre and bottom) 4. Provide the smallest width size as window size, do NOT take a deduction 5. Measure inside height in at least 3 places (left, centre and right) 6. Provide the smallest height size as window size, do NOT take a deduction 7. If a divider rail is required, measure from the inside bottom to the centre of the required divider rail location. Remember rails could vary up to 40mm if not specified critical. OUTSIDE MOUNT TRACK BIFOLDS Headboards are supplied as standard for track bifolds with top track attached. Sideboards and bottom boards are optional however sideboards are recommended for outside mount to provide better light block. It is common practice to mount headboard and sideboards outside of the architrave hard up against the wall. For this layout, you will need to add extra to your sizes to allow for boards. Ensure there is enough clearance for doorhandles. Track layouts are specified on the next page. 1. Measure outside of architrave width in at least 3 places (top, centre and bottom) 2. Add at least 38mm for sideboards (if required) as finish size 3. Measure outside of architrave height in at least 3 places (left, centre and right) 4. Add at least 19mm for headboard as finish size 5. If a divider rail is required, measure from the floor or outside of architrave to the centre of the required divider rail location. Remember rails could vary up to 40mm if not specified critical. 42

TRACK LOCATIONS – BIFOLD INSIDE MOUNT OPUS POLYMER ENCORE INSIDE & OUTSIDE (if boards ordered) 134mm 115mm 115mm 30mm 30mm 69mm 50mm 65mm 82mm 58mm 50mm 20mm 10mm 29mm 48mm 85mm 30mm 85mm 30mm 115mm 115mm 43

TECHNICAL MANUAL
19 JULY Technical Manual
Technical Manual - Doccheck
WINTIX Technical Manual - Ancare
Autosport Technical Manual - Deutsch
technical manual - Orvis
Technical Manual - Tyrolia
Technical Manual - Coutant.org
Technical Manual - Tyrolia
Technical Manual - BigHole.nl
Philmac Valves Technical Manual
Plumbers Technical & Installation Manual
Symposia Technical Manual - Kenes
CAPITOL IDEAS
Technical Manual Conservation Agriculture - weADAPT
Hanson Thermalite® technical manual - HeidelbergCement
Technical manual - Distribution Technology Home
Technical Manual 2011 - tech mavic
Technical Manual - Crane Merchandising Systems
Technical Manual