Views
4 months ago

CAPITOL TECHNICAL MANUAL

TRACK BYPASS INSIDE

TRACK BYPASS INSIDE MOUNT cont. OPUS INSIDE MOUNT ENCORE INSIDE MOUNT Attach L Bracket to underside of headboard Slide fascia between headboard and recess 16. Cover screw holes with screwcap stickers and gap fill if necessary to finish off. 17. Operate all louvre tilts and operate panels several times to make sure all components are working correctly. 18. Clean shutters and work space. OUTSIDE MOUNT: 1. Lay all of the framing pieces (boards) face up on the floor or your workspace. 2. Screw from above the headboard down into the sideboards. 3. Screw from sideboards into the bottom board if applicable, cover with screw caps. 4. Lift the assembled box unit and place against the wall in your measured position. 5. Tack into place with fixing screws taking care not to screw all the way into place. 6. Using a ladder: Fix the mounting block to the top of the headboard at the rear edge. For ENCORE aluminium shutters, use the 40x40 angle supplied as a mounting piece (diagrams below). 7. Screw through the mounting block or 40x40 angle into the wall, anchoring well: OPUS OUTSIDE MOUNT 40mm x 27mm Mounting block ENCORE OUTSIDE MOUNT 40mm x 40mm aluminium angle 62

TRACK BYPASS OUTSIDE MOUNT cont. 8. For OPUS, attach the metal headboard support bracket to the rear of the mounting block. 9. Make necessary adjustments to ensure box out frame is level. 10. Drive headboard fixing screws in all the way. 11. Mount the light block lengths supplied to the rear inside edge of the sideboards (or use angle brackets instead of light block if preferred). 12. Screw through the light block into the wall or architrave to attach the sideboards. 13. If no bottom board supplied, attach bottom tracks by measuring the distance from the edge of headboard to centre of each track and position the bottom tracks the same distance. Use the supplied double-sided tape to fix tracks in place direct to the floor. (Does not apply to bottom board as track is recessed). 14. Check all necessary hardware/componentry is fitted into the top track and panels. 15. Fit rear panels into the back track first, attaching the wheel carrier brackets to the wheel carriers in the top track and lock them in place. Compress the bottom guides and release into place in the bottom track. 16. If fitting co-joined panels, line panels up beside each other and drop hinge pins in to attach. 17. Make any necessary adjustments at the wheel carriers and sideboards to ensure panels are squared up and they operate correctly. 18. Cover screw holes with screwcap stickers and gap fill if necessary to finish off. 19. Attach returns to fascia if applicable using L brackets. 20. Attach L brackets to front edge of headboard according the diagrams below. 21. Position fascia 50mm above headboard then screw into bracket at rear of fascia. OPUS OUTSIDE MOUNT ENCORE OUTSIDE MOUNT Attach L Bracket to top face of headboard & screw into fascia Attach L Bracket to top face of headboard & screw into fascia 50mm 50mm 22. Cover screw holes with screwcap stickers and gap fill if necessary to finish off. 23. Operate all louvre tilts and operate panels several times to make sure all components are working correctly. 24. Clean shutters and work space. 63

Technical Manual
TECHNICAL MANUAL
TECHNICAL MANUAL - Affinage
19 JULY Technical Manual
EXHIBITION TECHNICAL MANUAL - Kenes
Technical Manual KS Ultimate
Technical Manual - Plastorgomma Service
Technical Reference Manual - Emtek
Exhibition Technical Manual - Kenes
Technical Manuals - A & Reds
MUFLEDRAIN TECHNICAL MANUAL - MUFLE.com
KITCHEN TECHNICAL MANUAL - Boffi
TECHNICAL MANUAL - Sharq.biz
Girth Gear Technical Manual
Evolution Technical Manual - Jemphrey
Technical Manual - Schwarzkopf Professional