8 months ago



CARE INSTRUCTIONS OPERATING SHUTTERS A polymer shutter is by nature, a flexible product. OPUS panels will flex in operation and require to be assisted when closing them by lifting the panel up into the frame against the magnetic catches. This is not a product fault but a feature of the shutter. With any shutter regardless of substrate, it is important to make sure louvres are closed before stacking bifolds, and sliding bypass closed panels to avoid breakage. Never slam panels closed. Rotate louvres daily. Panels are supplied with a tension screw for each rotation. This can be easily adjusted for louvres that may tighten over time or become loose. Always use a two-handed motion to open louvres. This avoids the creation of a stress point at the tilt rod screw site that occurs by using just one hand in the centre of a louvre. Stress points can cause breakage over time. Close louvres by pushing the edge of a louvre closed and running you hand in an upward direction along each rotation. Due to the nature of clearview shutters having play in the tilt rod, it may be necessary to push close individual louvres after the sweeping motion to obtain maximum light block. CLEANING OPUS shutters are made from a water resistant polymer extrusion with a low VOC waterborne paint finish, making them the easiest on the market to clean and maintain. When the shutters gather dust, simply wipe them down with warm soapy water as frequently as desired. Never use abrasive or caustic cleaning agents to avoid damaging the paint finish. Gumption or similar cleaning tools like the Chux Magic Eraser are suitable for spot cleaning to remove light marks such as scuff marks made with jewellery whilst operating the panels and louvres. ENCORE shutters are made from aluminium with a powdercoated finish. This makes them the most durable and the easiest to maintain. Dusting them occasionally is enough to keep them clean, however they can be wiped down with warm soapy water in the same way you would clean an OPUS shutter. ENCORE when installed internally has a satin matte powder coat finish. It is important you take care with jewellery not to scratch the powder coat, however fine marks may also be removed using a mild car polish or the Magic Eraser. Fingerprints on matte black finish can be removed with baby wipes. ENCORE when installed externally is more resilient to surface damage due to the high gloss powdercoat finish. Simply hose the shutters down regularly to keep them dust free and use soapy water to spot clean. 69

Technical Manual
Capitol Capitol - Minnesota's Private Colleges
Technical Manual. PDF - smartclad
Technical Manual - GC America
Technical Manual - Tyrolia
Technical Manual - Rlsd
A Technical Manual for Landowners, Loggers, and ... - Forestry
TECHNICAL MANUAL - Megasun Solar Systems
KomGuide - Technical Manual - Komet Group
JellyFish® filter technical manual - Humes
Capitol Celebrates 80 Years! - Capitol College
Capitol 02 - Consideratii generale