Steps to troubleshoot Logic Board Issues on Macbook

View info : - https://apple.repairscentre.com.au/

A MacBook doesn’t have a Mother <strong>Board</strong>, it has a <strong>Logic</strong>
<strong>Board</strong>. Its functioning is similar <strong>to</strong> the Mother <strong>Board</strong>
and it provides central connection <strong>to</strong> every part of
Macbook. So if your system goes through some
hardware malfunctioning, then you need <strong>to</strong> diagnose
the central system as well. Macbook has an inbuilt
diagnostic suit called Apple hardware test and it allows
you <strong>to</strong> <strong>troubleshoot</strong> a lot of issues. This utility was
released during the year 2000 and since the years, it
has only developed. But using this <strong>to</strong>ol requires a lot of
skill and knowledge and if you are not able <strong>to</strong> use it
properly, then you don’t need <strong>to</strong> worry. macbook
repair center has given a list of steps <strong>to</strong> <strong>troubleshoot</strong>
issues using the logic board.

<strong>Steps</strong> for <strong>troubleshoot</strong>ing are:
1- Insert Apple hardware disk in the drive. This utility is
readily available and would be found on the second
desk long with installation disks. But it could also be
found on some sites such as Github.
2- Restart your system. You have <strong>to</strong> restart the system
<strong>to</strong> initialize the diagnostic progress. To make sure that
Macbook loads up along the utility press and hold the
key D.
3- Once setup is initiated, select the preferred
language and click on next.

4- When you will encounter interface of diagnostic
<strong>to</strong>ols, press the key T <strong>to</strong> run tests. This test will run for
10 minutes.
5- The last scan was a quick scan, now this scan will be
a deep scan. To run the scan click on the checkbox next
<strong>to</strong> “perform extended testing”, and then click on test
but<strong>to</strong>n. This test will run for few minutes depending
upon the damage.
This <strong>to</strong>ol will tell you all about the malfunctions but
not only this, this <strong>to</strong>ol will also look for
<strong>troubleshoot</strong> if there are software issues. With this,
you can have your malfunctions fixed in no time.
But if you still have doubts or are unable <strong>to</strong>
<strong>troubleshoot</strong> problems, then we recommend you <strong>to</strong>
contact Macbook helpdesk <strong>to</strong> get more
information.

Original Source :-
https://bit.ly/2KvuuWR