Genisys User Guide - OTC
Genisys User Guide - OTC
Genisys User Guide - OTC
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Step 3: View the Quick Test Results<br />
After you connect the cable and press the ENTER<br />
key on the scan tool, use the following steps if either<br />
the System Readiness Test message screen or the<br />
Quick Test results screen appears.<br />
NOTE: The Quick Tests provide a quick link to the vehicle’s<br />
PCM for viewing OBD II emissions readiness tests<br />
and DTCs.<br />
Figure 3.16: System Readiness Test Message Screen and Quick<br />
Test Results Screen<br />
3: Scan Diagnostics Applications<br />
Test Startup and Vehicle Connection<br />
1 If the “System Readiness Test, Not all supported tests<br />
are complete” message appears, press the OK function<br />
key to continue. The screen displays the message<br />
“Performing Quick Tests” and then displays the Quick<br />
Tests results screen, shown above.<br />
NOTE: If the system tests are not complete, press<br />
the EXIT key twice to return to the Required Cable<br />
illustration screen. Then, start the vehicle, drive it<br />
around for a few minutes, leave the engine running,<br />
and press the scan tool’s ENTER key to run the<br />
tests again.<br />
2 Use the Up and Down Direction keys to scroll<br />
through the test results.<br />
3 Optionally, print the test results. Refer to Printing on<br />
page 75.<br />
4 After viewing the Quick Test results, press the ENTER<br />
key.<br />
5 Continue with Step 4: Select the Diagnostic<br />
Function on page 20.<br />
Scan Tool <strong>User</strong> <strong>Guide</strong> 19