Views
5 years ago

0712-0299ZX60USB-3 - Flannery Plant Hire

0712-0299ZX60USB-3 - Flannery Plant Hire

MAINTENANCE 4. Rotate

MAINTENANCE 4. Rotate the hexagon section on the bottom of filter case (6) counterclockwise using a tool such as a wrench to remove filter case (6) from head cover (5). 5. While rotating filter element (7), pull to remove filter element (7) downward. 6. Replace O-ring (8) with a new one. 7. Securely install O-ring (8) in the O-ring groove on head cover (5). 8. Coat the seal on new filter element (7) with clean hydraulic oil. Completely install filter element (7) into filter head (4) while rotating filter element (7) taking care not to damage the filter element. 9. Take care not allow dust and/or water enter the filter case. 10. Install case (6) into head cover (5) while rotating the case clockwise. Tightening Torque: 25 to 35 N⋅m (2.5 to 3.5 kgf⋅m, 18.0 to 26 lbf⋅ft) 11. After replacing the filter element, bleed any remaining air from the hydraulic circuit while running the engine at a slow speed for approx. 3 minutes. 12. Check the oil level in the hydraulic oil tank. Add oil as needed. 13. Install under cover (2). 14. Tighten the hydraulic oil tank cap. 7-34 8 7 6 5 4 M1M7-07-072 M503-07-031 M1M7-03-004

Check Hoses and Lines --- daily --- every 250 hours MAINTENANCE CAUTION: • Escaping flammable fluid may cause fire. Check for missing or loose clamps, kinked hoses, lines or hoses that rub against each other and/or come in contact with other components, and any oil leaks. • Escaping fluid under pressure can penetrate the skin causing serious injury. To avoid this hazard, search for leaks with a piece of cardboard. Take care to protect hands and body from high-pressure fluids. If an accident occurs, see a doctor familiar with this type of injury immediately. • Repair or replace any missing, loose or damaged clamps, hoses, and lines. • Do not bend or strike high-pressure lines. • Never install bent or damaged hoses or lines. Check hoses and lines for oil leaks and/or damage while referring to the following tables. If any abnormality is found, repair it as instructed in the remedy column. Hoses Interval (Hours) Daily Hose surface Hose end Hose connection Every 250 hours Check Point Abnormality Remedy Hose surface Hose end Hose surface Hose surface Hose Hose and hose fitting Oil leak (1) Oil leak (2) Oil leak (3) Oil leak (4) Oil leak (5) Exposed reinforcement (6) Blister (7) Acute bend (8), Collapse (9) Deformation or Corrosion (10) 7-35 Replace Replace Retighten or replace hose or O-ring Replace Replace Replace Replace Replace Replace 3 2 3 2 SA-031 SA-292 SA-044 1 2 3 M137-07-008 1 2 3 M115-07-145

colour - Green Design Plant Hire
Ridgway Rentals Plant Machinery Guide May 17
WARNING - Flannery Plant Hire
Untitled - Flannery Plant Hire
Untitled - Flannery Plant Hire
Untitled - Flannery Plant Hire
Untitled - Flannery Plant Hire
Untitled - Flannery Plant Hire
GP.SERVICES - Sonic Plant Hire
MINIMIX 150 - Rapid Plant and Tool Hire
Ec13 - Plant Hire UK Limited
EC13 - Plant Hire UK Limited
plant list - Belmont Engineering
8457 JS145HD Spec (UK) Issue 3