Views
5 years ago

0712-0299ZX60USB-3 - Flannery Plant Hire

0712-0299ZX60USB-3 - Flannery Plant Hire

NOTE: When disconnecting

NOTE: When disconnecting a coupler located in a narrow space that is difficult for your hand to enter, use a screwdriver following the procedures as described below. MAINTENANCE Using Screwdriver A screwdriver with a tip thickness of less than 1 mm and a tip width of approx. 5 mm is appropriate to this work. • Slightly push the hose toward the coupler approx. 2 mm. • While pushing the hose toward the coupler, insert a screwdriver in the position as illustrated to the right. Twist the screwdriver about 90 °. After making the gap between the adapter and the dust prevention cover more than 2mm, pull the hose to disconnect the coupler. 3. Precautions for Re-using Coupler • Before connecting the coupler, be sure to check the coupler surface for any adhered foreign matter. Clean to remove the foreign matter if any. Adhered foreign matter may cause oil leaks and/or disconnection of the coupler. • When a hose clamping is required, put a clamp 200 mm away from the joint edge. If the hose is clamped as illustrated to the right, the coupler joint may slide as oil pressure changes, causing oil leaks due to the premature inner parts wear. • Do not use the coupler as a foot step and do not handle the coupler roughly. If the dust prevention cover is broken, the coupler may become difficult to disconnect. • Do not paint on the joint surface. The body will be seized with the dust prevention cover so that the coupler cannot be disconnected. 7-40 Screwdriver Adapter Less than 200 mm M1LA-07-021 Dust Prevention Cover M1LA-07-022 M1LA-07-019 M1LA-07-020

E. FUEL SYSTEM MAINTENANCE CAUTION: Fuel is highly flammable. Handle fuel with care. Keep open flame or sparks away from fuel. Refueling After parking the machine on a level surface, check the fuel level with fuel gauge (1) and level gauge (2). When necessary to add fuel, remove fuel tank cap (3) and refill fuel. NOTE: Even though the key switch is OFF, the fuel level can be checked by pressing and holding display selector (5) for longer than 0.5 seconds. As long as display selector (5) is kept pressed, the fuel level is displayed. As soon as the switch is released, the display disappears. 1. To avoid condensation, fill the tank at the end of each day’s operation. Take care not to add more fuel than the specified level. Fuel Tank Capacity: 120 L (31.7 US gal) 2. After refilling fuel, close tank cover (4). Be sure to lock the cover to prevent vandalism. IMPORTANT: • Take care not to allow water and/or dirt to enter the fuel system when refilling fuel. • This machine is equipped with Automatic Fueling Device. Remove cap (3) and add oil via fill opening until it is between the marks on the level gauge (2) of fuel oil tank. Avoid over filling. Change switch (6) to the OFF position to stop filling. Bleed Air from Fuel System Air in the fuel system will cause the engine to start hard and/or run roughly. Be sure to bleed air from the system after replacing the fuel filter or draining the tank. Automatic bleeding device is provided on this machine. 1. Confirm that the fuel level is more than one-half of the tank capacity. If the fuel level is lower, automatic bleeding device will not operate. Add fuel. 2. Turn the key switch ON and hold for 10 to 15 seconds. 3. Start the engine and check the fuel system for fuel leaks. 7-41 Fill Opening 3 2 6 1 5 M1M7-01-028 3 2 4 M1M7-03-004 Automatic Fueling Device M1M0-07-038

Ridgway Rentals Plant Machinery Guide May 17
3. Fusarium mycotoxins in cereals - Plant Research International ...
Neuson Zero-Tail Swing Excavator 50Z3/6003 - Chase Plant Hire
Get inspired by - Green Design Plant Hire
Quick Coupler Safety Quick Coupler Safety - Flannery Plant Hire
4878 JS200W Spec (Iss2) (UK) - Flannery Plant Hire
s130 skid-steer loader specifications - Ringby Plant Hire Ltd
MINIMIX 150 - Rapid Plant and Tool Hire
ALR 900 | AVR 1100 - PSM PLANT & TOOL HIRE CENTRES LTD
Hiring cell gatekeepers - ABC transporters in plant ... - BioTechnologia
15. LOADERS - CPHA - Contractors Plant Hire Association
New Copy of Stock List Hire Rates - Baileys Plant Hire Ltd
Pacific Coast Canola Begins Hiring for New Plant - Legumex Walker ...
JCB TRACKED EXCAVATOR | JS130 L T.A.B. - Exuma Plant Hire
Atlas Copco Portable air compressors Series 7, - Plant Hire UK Limited
Hilti - TE15-C - Light Duty Electric Breaker - Exsel Plant & Tool Hire Ltd
CES 3 2011 Hire of Plant SCHEDULES - Drakenstein municipality