Views
5 years ago

RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data

RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data

Installation RSU-503 Redundancy Switch Unit Figure 2-2. RSU-503 External Connections 16 Rev. 8

RSU-503 Redundancy Switch Unit Installation 2.4.1 TX/IF Output (J1, J5) The TX/IF Output connectors are TNC connectors, each with an impedance of 50Ω. These connectors carry the IF uplink signal to the online RFT (Unit A or B). 2.4.2 RX/IF Input (J2, J6) The RX/IF Input connectors are TNC connectors, each with an impedance of 50Ω. These connectors carry the IF downlink signal from the online RFT (Unit A or B). 2.4.3 TX/RF Input (J3, J7) The TX/RF Input connectors are type N connectors, each with an impedance of 50Ω. These connectors carry the transmit uplink signal from the online RFT (Unit A or B). Rev. 8 17

Ethernet Switches - Installation, Troubleshooting ... - SWS a.s.
Software Installation and Licensing ... - Comtech EF Data
CXU-810 RAN Optimizer - Comtech EF Data
Converters MBT-5000 & MBT-5003 L-Band Up ... - Comtech EF Data
Using This Document Series - Comtech EF Data
WAN_Point-to-Point Protocol - Comtech EF Data
2.5 Configuring the Digital Data Channels - Comtech EF Data
Redundant Backup Switch (RBS) User Guide - Voltron
Agilent 34970A Data Acquisition/Switch Unit - Northwestern University
Xilinx DS202 Virtex-5 FPGA Data Sheet: DC and Switching ...