Views
5 years ago

RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data

RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data

RSU-503 Redundancy Switch Unit RSU-503L Option A.3 External Connections Note: The following connections, available on the RSU-503, are not available with the RSU-503L: • TX/RF Input (J3, J7) • TX/RF Output (J9) • TX/RF Output (J11) (test output only) CAUTION Failure to properly connect the units will result in loss of communications between the switch and the RFTs. All connections between the switch and other equipment are made through front panel connections, as shown in Table A-1 (refer to Figure A-3 for connector locations). Table A-1. RSU-503L External Connections Name Desig. Type Function Switch to RFT #A (Primary) TX/IF OUTPUT J1 TNC, 50Ω IF Uplink to Unit A RX/IF INPUT J2 TNC, 50Ω IF Downlink from Unit A MONITOR & CONTROL J4 26-pin Circ. Monitor and control See Section 2.4.4 for pinouts (See note) Switch to RFT #B (Backup) TX/IF OUTPUT J5 TNC, 50Ω IF Uplink to Unit B RX/IF INPUT J6 TNC, 50Ω IF Downlink from Unit B MONITOR & J8 26-pin Circ. Monitor and control CONTROL See Section 2.4.4 for pinouts Switch to Antenna (See note) WAVEGUIDE J10 19-pin Circ. Waveguide switch control SWITCH See Section 2.4.6.1 for pinouts Standby Unit Test Ports TX/IF INPUT J12 TNC, 50Ω IF input test signal RX/IF OUTPUT J13 TNC, 50Ω IF output test signal Switch to Modem Terminal Interface TX/IF INPUT J14 TNC, 50Ω IF Uplink RX/IF OUTPUT J15 TNC, 50Ω IF Downlink MONITOR & J16 26-pin Circ. Modem Terminal Interface (MTI) CONTROL See Section 2.4.12 for pinouts Ground GND ERDE None #10-32 Stud Chassis Ground Note: Refer to Section A.5 for addressing information. Rev. 8 A–3

RSU-503L Option RSU-503 Redundancy Switch Unit Figure A-3. RSU-503L External Connections A–4 Rev. 8

Software Installation and Licensing ... - Comtech EF Data
Converters MBT-5000 & MBT-5003 L-Band Up ... - Comtech EF Data