Views
5 years ago

vero uk training material - VCAM TECH Co., Ltd

vero uk training material - VCAM TECH Co., Ltd

Pre-requisite

Pre-requisite INTRODUCTION VISI Modelling – Draft Analysis It is important that before you attempt this VISI-Analysis training example; you must have completed and fully understood the previous VISI-Design and VISI-Modelling and VISI- Surface Modelling examples. During this exercise, it is assumed that the user has a basic knowledge of the VISI-Series software. Object The following example will highlight some of the required techniques to fully utilise the dedicated analysis functions within VISI-Modelling. Vcamtech Co., Ltd 1

Start by opening the workfile: - VISI Modelling – Draft Analysis File > Open Select the file named “Front Cover.wkf” The model should look as below: - The GREEN model will reside on the “Part 1” layer. Part 1 is to be used as the first revision of a plastic component. There will be a second ORANGE model that resides on the “Part 2” layer. The second model represents a second revision of the same component. We will use the VISI-Comparison module to check for the model differences between Part 1 and Part 2. Switch ON both the “Part 1” and “Part 2” layer to show both models together. Analysis > Compare Select the first body - Select PART 1 ( the original GREEN solid model ) Select the body to compare - Select PART 2 (the second ORANGE solid model ) NOTE : The comparison tolerance value can be changed from inside the compare control panel. Vcamtech Co., Ltd 2

YT-1200 - YOUNG TECH Co., Ltd.