Views
5 years ago

vero uk training material - VCAM TECH Co., Ltd

vero uk training material - VCAM TECH Co., Ltd

Bushing For Guide

Bushing For Guide Pillars VISI Mould - Tool Build Tutorial For the guide bush we will use the Hasco Z10 Guide Bush with Spigot, configured as shown below Guide Bush / Tube Dowels For the guide bush / tube dowels we will use the Hasco Z20 tube dowel configured as shown below. Make sure that the Alignment is set to a bottom position. Stop Buttons In this particular tool we will not be using Stop Buttons. Remove the “Tick” from the checkbox so that this component is not inserted. This checkbox will align the tube dowel to the bottom of the K11 plate Vcamtech Co., Ltd 10

Cap Head screws VISI Mould - Tool Build Tutorial For fixing together the ejector plates we will use a Hasco Z31 screw as configured below. Return Pins / Push Backs For the return pins we will be using Hasco Z41 type, this requires you to pick from the drop down list as shown below. When you have chosen the Z41 from the drop down list select the diameter 12. Shown below is the final configuration for the Z41 return pins. Cap Head Screw – Not Required Select the Drop Down arrow to pick from the available list. Select Z41 from the list. The final cap head screw in the list is not required for this design. This is an optional screw only required is 2 sets of ejector plates are being used in the design. Remove the “Tick” from the checkbox so that this component is not inserted. Vcamtech Co., Ltd 11