Views
5 years ago

vero uk training material - VCAM TECH Co., Ltd

vero uk training material - VCAM TECH Co., Ltd

Countersunk Ejector Pin – Not Required VISI Mould - Tool Build Tutorial The countersunk ejector pin in the list is not required for this design. This is an optional item only required if 2 sets of ejector plates are being used in the design. Preview the Standard Elements It is now possible to preview our Standard Elements configuration by using the preview facility. Click on the “Preview All Elements” icon to show the components within the mould. Remove the “Tick” from the checkbox so that this component is not inserted. Note :- Now that we have previewed the components, it is possible to adjust some of the sizes that were not available before the preview had taken place. Vcamtech Co., Ltd 12

Adjust Guide Pillar Lengths, Guiding length 75, Shoulder Length 56. Adjust the Guiding Length and Shouldered as shown opposite. VISI Mould - Tool Build Tutorial It is not necessary to change any of the other Standard Element default sizes, as they will be suitable for this tool design. Confirm the Standard Element configuration. To store the changes made to the Standard Element layout and take them out of preview mode we need to confirm the changes using the Apply button. Opening the Tool As a final operation we can open the tool by rotating around a specific axis. For this task we will need to switch back to the “Tool” interface. The first thing we need to do is to set our Cavity Insert to the Injection Side so that it will open onto the correct side. Setting the Injection side Click the “Injection” node in the tool tree and then Right Mouse Button to reveal the pop up options. Click the Apply button to store the Standard Element configuration. Click the “Set Injection side” option from the pop up. Vcamtech Co., Ltd 13

YT-1200 - YOUNG TECH Co., Ltd.