Views
5 years ago

vero uk training material - VCAM TECH Co., Ltd

vero uk training material - VCAM TECH Co., Ltd

VISI Modelling – Draft

VISI Modelling – Draft Analysis If you switch OFF the ‘show’ tick box in ‘Common zones’ and update the graphics, it is very quick and easy to see the design changes for the new revision of the solid model. Now we know what the design changes are, CANCEL out of the comparison module by pressing the “X”. We will continue to use the rest of the Analysis tools and work on Part 2 (ORANGE model). Switch ON only the Part 2 layer and also make it the current working layer (green arrow). Analysis > Draft Analysis Select the model to analyse – Select the ORANGE solid The design changes displayed without the common zones visible Select the plane normal – Select the Z axis (confirm using RHM) After selecting the plane normal a display panel will be presented to the left hand side. Using this control panel it is possible to manipulate the draft angle values Vcamtech Co., Ltd 5

9 1 2 VISI Modelling – Draft Analysis 1. Load default Parameters – This will allow you to load the default angle range values previously defined 2. Save Default Parameters – After setting the default angle range values, it is possible to save the values and recall them for another model. 3. Allows the user to re-select the direction for draft analysis. 3 4 5 4. Update graphics – Selecting this icon will update the display to represent any angle change. 5. Imprint Isocline curves – Selecting this icon will imprint the edges where each colour band changes onto the model. 6. Imprint Isocline curves and colour face sets – Selecting this icon will imprint the edges where each colour band changes and also maintain the face colours defined by the draft analysis control panel 7. Draw Isocline curves – Selecting this icon will create wireframe geometry where each colour band changes onto the model. 8. WPL by Direction. Will automatically create a new workplane based on the current draft analysis direction. 9. Angles evenly spaced – This option will automatically space the angle ranges evenly. For example, if you choose 8 divisions then the computed angle ranges will be 180°/8 (i.e. 22.5° each) Vcamtech Co., Ltd 6 6 7 8

YT-1200 - YOUNG TECH Co., Ltd.