5 years ago

vero uk training material - VCAM TECH Co., Ltd

vero uk training material - VCAM TECH Co., Ltd

Adding Lifters to the

Adding Lifters to the Design VISI Mould - Inserting Lifters Looking at the part closely you can see that there are 4 clip features that cause under cut conditions in the moulding this will require the use of lifters to mould these features without trapping the mould. The circles show 2 of the 4 clips that will require lifters. Lets begin to build the first lifter by following the next exercise: - To make the task of inserting the Lifters into the assembly easier, we will again filter the layers selecting only the ones relevant for the task. Select the Layer Group “Lifter Insertion” to activate the relevant layers. Make sure UPP is the Current Layer. Enable the Layers shown above, you can see that the lifter heads (x4) have already been modelled (U+A1, U+A2). Vcamtech Co., Ltd 2

The display should look like the one below. Begin by selecting the Standard Element menu. Select the General catalogue and Lifters Pick A_LIFTER4_FREE VISI Mould - Inserting Lifters Vcamtech Co., Ltd 3

YT-1200 - YOUNG TECH Co., Ltd.