Views
5 years ago

vero uk training material - VCAM TECH Co., Ltd

vero uk training material - VCAM TECH Co., Ltd

Now enter the parameters

Now enter the parameters as shown below for the Slide Plate. The Result VISI Mould - Slide Assembly Creation Here is what you should expect to see with the Slide Plate situated below the Slide body. Adding Guide Rails to the Slide Assembly Select the General Catalogue > Slider Core Make sure the Core layer is selected. Enter the Width, Height and Length as shown opposite. Slide Plate shown underneath the slide body. Vcamtech Co., Ltd Select the A_SLGUI_SCREW.This is a Slide Rail assembly with automatic insertion of fixing screws. 6

VISI Mould - Slide Assembly Creation We will need to select the appropriate Slide Body again to begin the insertion process for the Guide Rails. Pick the Slide anywhere on its body. Insert the parameters as shown below for the Left and Right Side guide rails. (Note:- We will leave the Screw parameters as default but they can be accessed and modified by scrolling down on this dialogue box.) Make sure Core layer is the target layer. These should be the default parameters when you first pick the Slide Body. If not please change them to match those opposite. Reminder: - When you have configured the parameters select the apply button to insert the component. Vcamtech Co., Ltd 7

YT-1200 - YOUNG TECH Co., Ltd.