SHC200.manual.v1

Seat Heater & Cooler w/ Single Switch
Controller and Dual Level Settings
Instruction Manual v1.0
Model #
SHC200
Table of Contents
1.0 What is in the Box ……...........……..................................................................................... Page 1
2.0 Key Features .…….....…...................…............................................................................... Page 1
3.0 Electrical System & Wiring Diagram …….......................................................................... Page 2
4.0 Specifications ……...................……....…............................................................................. Page 3
5.0 Installation Instructions …….................................................…....................................... Pages3
6.0 Operation ……........................…................................................…....................................... Pages3
1.0 What is in the Box
1.1 Heating Pad with 2 fans
1.2 Cooling Pad with 2 fans
1.3 Switch
1.4 Harness
Dual Pads
(Heater & Cooling)
Control Switch
2.0 Key Features
2.1 Dual seat heater and cooler
2.2 Dual Settings
2.3 Dual Pads Available
Accele Electronics 800-788-1212 Page
1

Seat Heater & Cooler w/ Single Switch
Controller and Dual Level Settings
Instruction Manual v1.0
Model #
SHC200
3.0 Electrical System & Wiring Diagram (Fig 3.0a)
3.1 Operating Voltage ---- 12 VDC
3.2 Heating Power Consumption ---- 32 Watts
3.3 Ventilation power Consumption ---- 8 Watts
3.4 Current Average Draw (Heating) ---- 2.7 amps
3.5 Current Average Draw (Ventilation) ---- 0.7 amps
3.6 Red Wire ---- IGN power +12 VDC
3.7 Black ---- Ground
Fig 3.0a
Accele Electronics 800-788-1212 Page
2

Seat Heater & Cooler w/ Single Switch
Controller and Dual Level Settings
Instruction Manual v1.0
Model #
SHC200
4.0 Specifications
4.1 Operating Voltage : 12 VDC
4.2 Current Draw (Max) : 2.7 amps
4.3 Material : Non-Woven Fabric's
4.4 Pad Size : 11.80 " x 13.39" (30 * 34 cm)
5.0 Installation Instructions
5.1 Take off the car seat and remove the leather cover.
5.2 Place the heater & cooler pad in the most appropriate position of the seat, locate the fan
position and mark it on the seat sponge. Punch holes in the sponge according to the size
of the fans.
5.3 Put the heater & cooler pad into the seat sponge.
5.4 Punched hole leather seats will give best results for the cooling function
6.0 Operation
6.1 Press left on switch to heat seat
* Press once for high level
* Press twice for low level
* Press three times to turn off
* Press left on switch to heat seat
6.2 Press Right of switch for cooler Seat
6.3 Press once for high level
6.4 Press twice for low level
6.5 Press three times to futrn off
Accele Electronics 800-788-1212
Page
3