Instruction Manual and Maintenance Tips for your dwt ... - dwt-Zelte
Instruction Manual and Maintenance Tips for your dwt ... - dwt-Zelte
Instruction Manual and Maintenance Tips for your dwt ... - dwt-Zelte
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
050139_<strong>dwt</strong>_Au bau_GB 10.10.2005 08:50 Uhr Seite 8<br />
Free St<strong>and</strong>ing Caravan Awnings, Motorcaravan-, Bus- <strong>and</strong><br />
Frame Tents<br />
Prepare everything<br />
� Check that the poles set is complete <strong>and</strong> according to the plan. Fix the screws <strong>and</strong> the pole clamps<br />
to the poles.<br />
Lay out the poles <strong>and</strong> corner pieces according to the plan on the ground <strong>and</strong> assembly the roof<br />
ring (corner, ridge- <strong>and</strong> gable poles). Roof front supports are not to be assembled yet.<br />
� Now put the upper vertical poles in the corner poles to make the further assembly easier. The<br />
lower vertical poles are fitted when the tent lies over the pole frame. Screws must always be<br />
directed downwards or inward.<br />
Now the erecting starts<br />
� If you have an awning with removable side walls, the walls should be taken out first.<br />
� Put the awning roof over the pole frame. Be careful with the corners <strong>and</strong> parts that stick out; they<br />
may damage the awning material <strong>and</strong> the windows!<br />
With frame tents the sun pelmet is assembled last.<br />
� Tents with a sun pelmet have pelmet supports that fit in the corner pieces. Tension the pelmet so<br />
that the gable seam is in front of the gable poles – not on the gable poles!<br />
� Now put the walls in <strong>and</strong> close all the zips. If there are telescopic poles you can now tension the<br />
roof.<br />
� Now fit the lower vertical poles in the upper vertical poles. If the poles are telescopic, you can<br />
adjust them to the desired height. With frame tents you fit the lower poles in the upper poles.<br />
�<br />
�<br />
�<br />
�