23.01.2013 Views

Perfecta Luftgewehr Mod. 55 cal. 4,5 mm (.177) - Umarex

Perfecta Luftgewehr Mod. 55 cal. 4,5 mm (.177) - Umarex

Perfecta Luftgewehr Mod. 55 cal. 4,5 mm (.177) - Umarex

SHOW MORE
SHOW LESS

Transform your PDFs into Flipbooks and boost your revenue!

Leverage SEO-optimized Flipbooks, powerful backlinks, and multimedia content to professionally showcase your products and significantly increase your reach.

4. Safe aiming and firing<br />

attention! Always make sure that the muzzle of your gun points into a safe direction.<br />

Never aim at a person or animals. Always treat your weapon as if it was loaded and ready to fire.<br />

After the pellet has been inserted, close the barrel, it must lock with<br />

an audible click. After the safety has been set to "fire", the weapon<br />

is ready to fire.<br />

Aim at a safe target. Hold the weapon in a way that the rear sight<br />

(with the rear sight notch) and the front sight are seen at the same<br />

time. The front sight must be situated precisely in the centre of the<br />

rear sight notch. Now lift the weapon until the lower edge of the bull's eye of the target "touches"<br />

the surface of the front sight. The upper side of the rear sight, the upper side of the front<br />

sight and the point of impact should now all be in one line.<br />

Note: The sights of the gun are equipped with special light collectors on rear sight and front<br />

sight which make aiming easier and quicker.<br />

5. Sight settings.<br />

The point of impact of the weapon can be adjusted infinitely variable by means of the micrometer<br />

adjustment. The adjustments of the point of impact are to be effected as follows:<br />

elevation adjustment:<br />

Point of impact too high:<br />

turn elevation adjustment screw to the right<br />

Point of impact too low:<br />

turn elevation adjustment screw to the left<br />

Windage adjustment:<br />

Point of impact too far right:<br />

turn windage adjustment screw to the left<br />

Point of impact too far left:<br />

turn windage adjustment screw to the right<br />

GB<br />

-10-<br />

elevation adjustment screw<br />

windage adjustment screw

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!