Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Introduction<br />
How the <strong>Dynamic</strong> <strong>Looper</strong> is structured<br />
The <strong>Dynamic</strong> <strong>Looper</strong> consists of the following blocks. (For a detailed block diagram, see page 43.)<br />
The signal received at the INPUT or MIC IN is processed by the Pre Effect (Pre FX), and then recorded in Loop 1 or Loop 2. Pre<br />
Effects are applied to the signal before the recorded loop.<br />
The Loop Effect (Loop FX) can be applied to the playback of the loop-recorded phrase during playback. You can modify the<br />
phrase by using the pedal to control the various effect parameters.<br />
Signal flow<br />
Record to a loop<br />
Program<br />
Play back loops<br />
Loop<br />
INPUT (Guitar)<br />
MIC IN<br />
MIC Trim<br />
Pre FX<br />
TARGET<br />
Pre FX<br />
Loop1<br />
Loop2<br />
Loop FX<br />
Master<br />
Limiter<br />
Output<br />
Control pedal<br />
Metronome<br />
Pre FX TARGET<br />
The Pre FX Target specifies whether the effect will be<br />
applied to the signal from the INPUT jack, to the signal from<br />
the MIC IN jack, or to both signals.<br />
Pre FX<br />
The Pre Effect is used to process the signal from the INPUT<br />
jack or the MIC IN jack.<br />
You can choose one of eleven effect types for the Pre Effect.<br />
Each effect lets you adjust up to two parameters. The<br />
adjustable parameters will differ depending on the effect<br />
that you select. You can use the control pedal to control<br />
effect parameters, allowing you to apply real time<br />
modifications to the phrase you’re performing.<br />
Loop<br />
Each loop records the signal from the Pre Effect.<br />
There are two loops: Loop 1 and Loop 2. You can record<br />
phrases totaling a recording time of 90 seconds for the two<br />
loops.<br />
9