Views
1 year ago

Sony HT-NT3 - HT-NT3 Mode d'emploi Anglais

Sony HT-NT3 - HT-NT3 Mode d'emploi Anglais

Note To receive a Dolby

Note To receive a Dolby Digital signal, you need to connect a TV or other devices to the TV (DIGITAL IN) jack with a optical digital cable. If your TV’s HDMI IN jack is compatible with the Audio Return Channel function (page 26), you can receive a Dolby Digital signal via an HDMI cable. Press AUDIO repeatedly until the signal you want appears in the front panel display. “MAIN”: Sound of the main language will be output. “SUB”: Sound of the sub language will be output. “MN/SB”: Mixed sound of both the main and sub languages will be output. Changing the brightness You can change the brightness of the front panel display and blue LED indicator. Press DIMMER repeatedly. You can select “OFF”, “DIM1” or “DIM2”.* * The brightness for “DIM1” and “DIM2” settings are the same. Note The front panel display is turned off when “DIM2” is selected. It turns on automatically when you press any buttons, then turns off again if you do not operate the system for about 10 seconds. However, in some cases, the front panel display may not turn off. Deactivating the buttons on the Bar Speaker (Child Lock) You can deactivate the buttons on the Bar Speaker (except for ) for preventing misoperation, such as child mischief. Be sure to use the buttons on the Bar Speaker to perform this operation. While holding INPUT, press VOL –, VOL + and VOL – in sequence. “LOCK” appears in the front panel display. You can only operate the system by using the remote control. To cancel, while holding INPUT, press VOL –, VOL + and VOL – in sequence. “UNLCK” appears in the front panel display. Saving power in Standby Mode Check that you have made the following settings: [Bluetooth Standby] is set to [Off] (page 24). [Control for HDMI] in [HDMI Settings] is set to [Off] (page 26). [Quick Start/Network Standby] is set to [Off] (page 26). [Remote Start] is set to [Off] (page 28). 34 GB

Enabling the IR repeater function (when you cannot control the TV) When the Bar Speaker obstructs the remote control sensor of the TV, the TV remote control may not work. In that case, enable the IR repeater function of the system. You can control the TV with the remote control of the TV by sending the remote signal from the rear of the Bar Speaker. 2 Press to select [Setup] at the upper right corner, then press . 3 Press / to select [System Settings], then press . 4 Press / to select [IR-Repeater], then press . 5 Press / to select [On], then press . Further settings for the wireless system Note Be sure to check that the remote control of the TV cannot control the TV, then set [IR-Repeater] to [On]. If it is set to [On] when the remote control can control the TV, appropriate operation may not be obtained, because of the interference between the direct command from the remote control and the command via the Bar Speaker. On some TVs, this function may not work correctly. In this case, place the Bar Speaker slightly further away from the TV. You can make further settings for the wireless system by using the [Wireless Sound Connection] settings. 1 Press HOME. The home screen appears on the TV screen. 2 Press to select [Setup] at the upper right corner, then press . 3 Press / to select [System Settings], then press . 4 Press / to select [Wireless Sound Connection], then press . The [Wireless Sound Connection] display appears. [Secure Link] (page 36) [RF Band]* (page 36) * This function may not be available in some countries/regions. Other Functions 1 Press HOME on the remote control of the system. The home screen appears on the TV screen. 35 GB