Views
7 months ago

Sony NEX-C3A - NEX-C3A Consignes d’utilisation Anglais

Sony NEX-C3A - NEX-C3A Consignes d’utilisation Anglais

Battery charger • Only

Battery charger • Only NP-FW type battery packs (and no others) can be charged in the battery charger (supplied). Batteries other than the specified kind may leak, overheat, or explode if you attempt to charge them, posing a risk of injury from electrocution and burns. • Remove the charged battery pack from the battery charger. If you leave the charged battery pack in the charger, battery life may be shortened. • The CHARGE lamp of the supplied battery charger flashes in either way: Fast flashing: Turns the light on and off repeatedly at the interval of 0.15 seconds. Slow flashing: Turns the light on and off repeatedly at the interval of 1.5 seconds. • When the CHARGE lamp flashes fast, remove the battery pack being charged, and then insert the same battery pack into the battery charger securely again. When the CHARGE lamp flashes fast again, this may indicate a battery error or that a battery pack other than the specified type has been inserted. Check that the battery pack is the specified type. If the battery pack is the specified type, remove the battery pack, replace it with a new one or another one and check if the battery charger operates correctly. If the battery charger operates correctly, a battery error may have occurred. • When the CHARGE lamp flashes slowly, it indicates that the battery charger stops charging temporarily on standby. The battery charger stops charging and enters the standby status automatically when the temperature is outside of the recommended operating temperature. When the temperature gets back within the appropriate range, the battery charger resumes charging and the CHARGE lamp lights up again. We recommend charging the battery pack in an ambient temperature of between 10 °C to 30 °C (50 °F to 86 °F). • If the battery charger is dirty, batteries may not be charged correctly. Clean the battery charger with dry cloth, etc. Table of contents Sample photo search Menu search Index 164 GB

Mount Adaptor Using the Mount Adaptor LA-EA1 (sold separately), you can attach an A-mount lens (sold separately) to your camera. For details, refer to the operating instructions supplied with the Mount Adaptor. Table of contents Sample photo search Notes • You may not be able to use the Mount Adaptor with certain lenses. Consult your Sony dealer or local authorized Sony service facility on compatible lenses. • The continuous shooting speed of still images will be slower. Autofocus function with A-mount lenses Upgrading Mount Adaptor LA-EA1 (sold separately) makes autofocus (Single-shot AF) possible when an A-mount SAM or SSM lens is attached to the camera. You can also use autofocus (Single-shot AF) in movie recording mode by pressing the shutter button halfway down. Menu search Index Notes • You cannot use the AF illuminator when using an A-mount lens. • The autofocus speed will be slower compared to when an E-mount lens is attached. (When an A-mount lens is attached, the autofocus speed will be about 2 seconds to 7 seconds, when shooting under Sony measurement condition. The speed may vary depending on the subject, ambient light, etc.) • The sound of the lens and the camera in operation may be recorded during movie recording. You can avoid this by selecting [Menu] t [Setup] t [Movie Audio Rec] t [Off]. • It may take a long time or may be difficult for the camera to focus, depending on the lens used or the subject. 165 GB