Views
1 month ago

Sony CCD-TR412E - CCD-TR412E Consignes d’utilisation Russe

Sony CCD-TR412E - CCD-TR412E Consignes d’utilisation Russe

English Trouble check If

English Trouble check If you run into any problem using the camcorder, use the following table to troubleshoot the problem. Should the difficulty persist, disconnect the power source and contact your Sony dealer or local authorized Sony service facility. Camcorder Power Symptom The power is not on. The power goes off. The battery pack is quickly discharged. While charging the battery pack, no indicator appears or the indicator flashes in the display window. The camcorder turns on/off when using the accessory which is attached to the intelligent accessory shoe. (CCD-TR840E/TR845E only) Cause and/or Corrective Actions • The battery pack is not installed. m Install the battery pack. (p. 8) • The battery is dead. m Use a charged battery pack. (p. 9) • The AC power adaptor is not connected to the mains. m Connect the AC power adaptor to the mains. (p. 32) • While being operated in CAMERA mode, the camcorder has been in Standby mode for more than 5 minutes. m Turn STANDBY down once and then up again. (p. 14) • The battery is dead. m Use a charged battery pack. (p. 9) • The camcorder does not operate when using a battery pack that is not an “InfoLITHIUM” battery pack. m Use an “InfoLITHIUM” battery pack. (p. 83) • The ambient temperature is too low. (p. 81) • The battery pack has not been charged fully. m Charge the battery pack again. (p. 9) • The battery pack is completely dead, and cannot be recharged. m Use another battery pack. (p. 82) • The AC power adaptor is disconnected. m Connect it firmly. • Something is wrong with the battery pack. m Contact your Sony dealer or local authorized Sony service facility. • The camcorder is working with the AC power adaptor. m Use the battery pack. Operation Symptom START/STOP does not operate. Cause and/or Corrective Actions • The tape is stuck to the drum. m Eject the tape. (p. 13) • The tape has run out. m Rewind the tape or use a new one. (p. 26) • The POWER switch is set to PLAYER. m Set it to CAMERA. (p. 14) • The tab on the cassette is out (red). m Use a new tape or slide the tab. (p. 13) 92

Trouble check Symptom Recording stops in a few seconds. The cassette cannot be removed from the holder. { and 6 indicators flash and no function except for cassette ejection works. The date or time indicator is flashing. The tape does not move when a video control button is pressed. The Steady Shot function does not activate. (CCD-TR640E/TR840E/ TR845E only) The autofocusing function does not work. (CCD-TR511E/TR640E/ TR840E/TR845E only) The fader function does not work. (CCD-TR511E/TR640E/TR840E/ TR845E only) No sound or only a low sound is heard when playing back a tape. (CCD-TR840E/TR845E only) Excessive high-pitched sound is heard. (CCD-TR840E/TR845E only) Data code becomes “--:--:--”. (CCD-TR845E only) The date or time indicator disappears. Cause and/or Corrective Actions • The START/STOP MODE switch is set to 5SEC or . m Set it to . (p. 19) • The battery is dead. m Use a charged battery pack or the AC power adaptor. (p. 9, 32) • Moisture condensation has occurred. m Remove the cassette and leave the camcorder for at least 1 hour. (p. 85) • You pressed DATE and TIME together for more than 2 seconds. m The camcorder is not malfunctioning. You may start recording. Flashing will stop soon. • The lithium battery is weak or dead. m Replace the lithium battery with a new one. (p. 74) • The POWER switch is set to CAMERA or OFF. m Set it to PLAYER. • The tape has run out. m Rewind the tape or use a new one. (p. 26) • STEADYSHOT is set to OFF. m Set STEADYSHOT to ON. (p. 62) • The Steady Shot function does not work when the wide mode is set to 16:9 FULL. • FOCUS is set to MANUAL. m Set it to AUTO. (p. 50) • Shooting conditions are not suitable for autofocus. m Set FOCUS to MANUAL to focus manually. (p. 50) • The START/STOP MODE switch is set to 5SEC or . m Set it to . (p. 19) • A title is displayed. m Stop superimposing the title. (p. 55) • The stereo tape is played back with HiFi SOUND set to 1 or 2 in the menu system. m Set to STEREO in the menu system. (p. 34) • The picture has been recorded with WIND set to ON in the menu system. m When there is no wind, set it to OFF. (p. 34) • You are playing back a portion of tape on which you wrote or erased the index signal. This is not a malfunction. (p. 72) • Reset the date and time. (p. 76) Additional information / Дополнительная информация (to be continued) 93