Views
6 months ago

Sony FDR-X1000VR - FDR-X1000VR Manuel d'aide Anglais

Sony FDR-X1000VR - FDR-X1000VR Manuel d'aide Anglais

BACK: Returns to the

BACK: Returns to the [TCSET] menu. When selecting [UBSET] PrSet: Sets the user bit. Set four 2-digit numbers, then press the ENTER button. The user bit can be selected within the following range. 00 00 00 00 - FF FF FF FF RESET: Initializes the user bit. Press the ENTER button to display [SURE?] while [OK] is displayed, then press the ENTER button again. T.REC: Sets the recording time of the user bit. OFF: Does not record the time as a user bit. ON: Records the time as a user bit. BACK: Returns to the [UBSET] menu. Note When [V.FMT] is set to [MP4], [TC/UB] is not available. [47] How to use Changing the Settings Camera settings IR-Remote Control

You can start/stop recording and initialize the time code using the infrared remote control (RMT-845 (sold separately)). 1. Press the NEXT button or PREV button to select [SETUP] - [CONFG] - [IR-RC], then press the ENTER button. 2. Press the NEXT button or PREV button to select the following setting, then press the ENTER button. ON: Allows you to operate the camera using the infrared remote control. OFF: Prevents operation of the camera using the infrared remote control. BACK: Returns to the [IR-RC] menu. Note The infrared remote control RMT-845 (sold separately) is required to use this function. Purchase it at a Sony service center. You can operate only the following settings using the RMT-845 (sold separately). Other settings are inoperable. Initialize the time code. When initializing the setting, the REC lamp lights in blue. Start/stop recording. [48] How to use Changing the Settings Camera settings HDMI settings Set the HDMI output signal. 1. Press the NEXT button or PREV button to select [SETUP] - [CONFG] - [HDMI], then