Views
2 months ago

Sony SLT-A33 - SLT-A33 Consignes d’utilisation Anglais

Sony SLT-A33 - SLT-A33 Consignes d’utilisation Anglais

Cleaning the image

Cleaning the image sensor If dust or debris enters the camera and lands on the image sensor (the part that acts as the film), it may appear on the photo image, depending on the shooting environment. If there is dust on the image sensor, clean the image sensor following the steps below. Notes • Cleaning cannot be performed when the battery level is 50% or less. • The camera starts beeping if the battery pack becomes low during cleaning. Stop cleaning immediately and turn the camera off. The use of an AC-PW20 AC Adaptor (sold separately) is recommended. • The cleaning should be completed quickly. • Do not use a spray blower because it may scatter water droplets inside the camera body. To clean the image sensor automatically using the cleaning mode of the camera 1 Confirm that the battery is fully charged (page 22). 2 Press the MENU button, then select 2 with b/B on the control button. MENU button 3 Select [Cleaning Mode] with v/V, then press the center of the control button. 36

4 Select [Enter] with v, and press the center of the control button. The image sensor vibrates for a short time, and eliminates dust from the sensor. 5 Turn off the camera. To clean the image sensor using a blower If another cleaning is needed after using the cleaning mode, clean the image sensor using a blower following the steps below. 1 Perform the cleaning operation described in steps 1 to 4 of “To clean the image sensor automatically using the cleaning mode of the camera.” Preparing the camera 2 Detach the lens (page 27). 3 Push the V mark on the mirror lock lever with a finger to lift up the mirror. • Be careful not to touch the surface of the mirror. Mirror lock lever 37