Views
8 months ago

Sony DTC-ZE700 - DTC-ZE700 Consignes d’utilisation Portugais

Sony DTC-ZE700 - DTC-ZE700 Consignes d’utilisation Portugais

• • • • Basic

• • • • Basic Operations Recording on a DAT 3 45 7 MODE RESET OPEN/CLOSE § ≠ AMS ± ANALOG OPTICAL COAXIAL INPUT • • • 0 48 kHz 44.1 kHz LONG REC MODE STANDARD • • • ) • • SBM ON OFF REC MUTE R 3 1 REC LEVEL 5 4 • 2 8 • 0 • • L 6 10 • R • 7 9 POWER g TIMER REC OFF PLAY START ID AUTO RENUMBER REHEARSAL WRITE ERASE MARGIN RESET · p P r REC PHONES PHONE LEVEL 0 10 2 8 6 See pages 4 and 5 for hookup information. 1 2 Press 3 Press Turn on the amplifier and play the program source you want to record. POWER. OPEN/CLOSE § and insert a Window side up cassette.OPEN/CLOSE OPEN/CLOSE § b b § 4 Set INPUT to the corresponding input connector. To record through Insert the cassette beyond the silver bar. Set INPUT to Close the cassette holder by pressing OPEN/CLOSE §. ANALOG IN DIGITAL OPTICAL IN DIGITAL COAXIAL IN ANALOG OPTICAL COAXIAL 6 EN 3-858-189-11(1)

Basic Operations 5 Locate the position where you want to start recording. To record from the beginning of the tape Press 0 to rewind the tape to its beginning. To record from the end of the recorded portion 1 Press 0 to rewind the tape to its beginning. 2 Press ). The deck locates the end of the recorded portion on the tape and stops automatically. 6 Press r REC. The deck becomes ready to record. 7 When recording the analog input signal, adjust the recording level with REC LEVEL. z If “UNLOCK” appears in the display The program source is not connected to the deck properly or is not turned on. Make sure that the program source is properly connected or turned on. 8 Press 9 Start The recommended recording level is 3. For details, refer to “Adjusting the Recording Level for Analog Recording” on page 10. P or ·. Recording starts. playing the program source. When the tape reaches the end, the deck rewinds it automatically to its beginning and stops (Auto Rewind). Basic Operations To Press Stop recording Pause recording Take out the cassette p P. Press the button again to resume recording. OPEN/CLOSE § after stopping recording To prevent accidental erasure Slide the record-protect tab to the left as shown in the illustration below. Recording is impossible (the hole is open). Recording is possible (the hole is closed). 7 EN 3-858-189-11(1)