Kühlschrank Refrigerator Réfrigérateur Koelkast Frigorífico ... - Severin

4. Carefully lift up the door and place it on a
suitable surface to protect it from scratches.
5. Take off the white plug (7) and re-position it
in the corresponding hole on the right-hand
side, pushing it firmly down.
6. Remove the two threaded bolts (1) securing
the lower hinge plate (2) on the right-hand
side.
7. Take out the left-hand adjustable foot (4) and
fit it on the opposite side.
8. Mount the lower hinge plate (2) in its new
position on the left-hand side, using the
threaded bolts (1). Ensure that the hinge plate
is aligned parallel to the side edge of the
fridge.
9. Replace the door in its new position. Ensure that the lower hinge pin is inserted into the
corresponding guide bush on the door.
10. Mount the upper hinge plate (5) in its new position on the left-hand side, using the two threaded
bolts (6). Ensure that the hinge pin is inserted into the corresponding guide bush in the door.
(Do not fully tighten the bolts yet).
11. Ensure that the door is in its properly closed position before tightening the bolts holding the
lower and upper hinge plates.
12. Open the fridge door, place the top panel (9) on top of the unit and fit the cover plate (8) into the
opening on the right-hand side of the top panel.
13. Replace the screws (10) and screw covers (11) on the top panel (9).
14. Put the unit back in its intended position and wait for about two hours before connecting it to
the mains.
Temperature control
The unit is re-activated by connecting it to the mains. It is only switched off
completely when the plug is removed from the wall socket.
The temperature in the refrigerator cabinet can be adjusted by setting the
temperature control. Turning the control clockwise will decrease the
temperature, while turning it anti-clockwise will increase it.
– After switching on, set the temperature control to its maximum setting.
– After approx. 30 minutes, the setting should be changed to a medium position, usually sufficient
for home or office use.
– Following a power interruption, or if the unit has been disconnected from the mains, there may
be a delay of 3 to 5 minutes before the unit automatically switches on again.
In position ‘0’, the cooling function is switched off, though the appliance is still connected to the
mains.
Interior light
Changing the light bulb:
– Remove the plug from the wall socket.
– Use a suitable screw-driver to remove the screw holding the light cover and take the cover off.
– Take out the defective bulb and fit a new one (max. 15 W).
– Slide the cover back into position, replace the screw and tighten it.
14