1 informazioni generali - Betamotor

REPLACING THE REAR LIGHT BULB
5
To replace the back light unit A, proceed
as follows:
• Remove the plate holder as described
in the section, “Removal of body parts”
on page 60.
• Disconnect all electric connections.
B
• Loosen the two screws B under the
fender.
• Pull out the faulty light unit A and replace
it with a new one.
• To fi t it all back in, proceed in reverse.
D
C
A
Note:
Any replacement lamp must meet the
same specifi cations as the original ones
(see section, “Light specifi cations”, page
76).
REPLACING THE LICENCE PLATE BULBS
To replace the plate number light, proceed
as follows:
REPLACEMENTS
• Loosen the screw C.
• Remove the transparent screen D.
• Pull the faulty light out of the bulb and
replace with a new one.
• To fi t it all back in, proceed in reverse.
Note:
Any replacement lamp must meet the
same specifi cations as the original ones
(see section, “Light specifi cations”, page
76).
75 GB