Views
5 months ago

KitchenAid 900 161 86 - 900 161 86 EN (854148801020) Istruzioni per l'Uso

KitchenAid 900 161 86 - 900 161 86 EN (854148801020) Istruzioni per l'Uso

54804-gb.fm5 Page 13

54804-gb.fm5 Page 13 Thursday, April 5, 2001 6:04 PM Technical information for the installer • After removing the oven from its packaging, before making the connections place it on the polystyrene foam base to protect it from damage. • Do not attempt to lift the oven by the handle. Lift at the sides as shown in the figure (see arrow). • Check that the appliance has not been damaged in transit. • Oven dimensions and kitchen unit dimensions are shown in the opposite figure. • For installation of the cooking hob, refer to the product description sheet. INSTALLATION • Kitchen units in contact with the oven must be heat resistant (80° C min). • Carry out the electrical connections between cooktop and oven (see chapter “Electrical Connection”). • Install the oven in the housing, lifting it at the sides, taking care not to trap the wires of the electrical supply cable. • For correct ventilation, follow the ventilation opening directions shown in the figure (at least 500 x 80 mm or an equivalent area). Also provide for at least 5 mm clearance between the top of the oven and the lower edge of the worktop. This space must not be obstructed by cross rails or other structural elements. • During oven installation, care must be taken to ensure that the sides are not touching the front edges of the housing or adjacent drawers and doors (see picture). No contacts • Secure the oven to the kitchen unit with screws (A) as shown. 13

54804-gb.fm5 Page 14 Thursday, April 5, 2001 6:04 PM • Warning: Do not connect to the power supply before you have finished connecting the oven and the cooktop. • Make sure the oven is installed and connected to the electricity supply by a qualified technician in accordance with the manufacturer’s instructions and in compliance with local regulations. • The installer is responsible for the correct electrical connection of the oven and the observance of the relative safety prescriptions. INSTALLATION ELECTRICAL CONNECTION • The oven must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. • The appliances must be earthed by law. • Do not use multiple plug adapters or extension leads. • After the oven has been installed, the electrical components must be inaccessible. See separate installation instructions supplied with the cooktop. Electrical connection between different models of hobs and oven Attention: The figures represent the right hand section of the oven, seen from the top, with the observer standing in front of the oven door. • Put clamp “B” into the first holes of junction block “C” starting from the left (as shown). • Connect the earth wire (D) of the cooktop to the oven (E) as illustrated. B C B C B C • Mount the corresponding knobs in the control panel last 4 gas burners hob: position of the knobs in the front controls hob 3 gas burners/1 electric hot plate hob: position of the knobs in the front controls hob Glass ceramic hob: position of the knobs in the front controls hob Glass ceramic hob (with 2 double cooking zones): position of the knobs in the front controls hob 14