Views
8 months ago

KitchenAid 901 506 22 - 901 506 22 EN (857921516020) Istruzioni per l'Uso

KitchenAid 901 506 22 - 901 506 22 EN (857921516020) Istruzioni per l'Uso

61002001.book Page 14

61002001.book Page 14 Tuesday, March 25, 2008 4:46 PM INSTALLATION INSTRUCTIONS Recommendations IMPORTANT: Unplug the oven before any cleaning and maintenance operations. • Installation must be carried out by a qualified technician according to the manufacturer's instructions and in compliance with the current local regulations • After unpacking the oven, make sure it has not been damaged during transport and that the door closes properly. In case of any doubts, contact the dealer or the nearest After-Sales Service. Preparation of cabinet for fitting • Cabinets in contact with the oven must be heat resistant (min. 90 °C). • Carry out all cabinet cutting work before fitting the oven. Carefully remove any chips or sawdust that could compromise oven operation. • The bottom of the oven must not be accessible after installation. • During installation make sure the sides of the oven do not touch the adjacent units. • For correct appliance operation, the minimum opening required between the worktop and the top of the oven must not be obstructed. Electrical connection Regulations require the appliance to be earthed. • Electrical connection must be carried out by a qualified technician according to the manufacturer's instructions and in compliance with the current local regulations. • The installer is responsible for correct electrical connection and compliance with the safety regulations. • The power cable must be long enough to make the electrical connection of the oven fitted in the cabinet. • The safety directives require a multi-pole switch with contact gap of at least 3 mm to be used during installation. • After installation, the electrical components must be inaccessible. Connecting the oven to the power supply • Make sure the voltage indicated on the dataplate is the same as the mains voltage. The dataplate is on the front edge of the oven (visible when the door is open). • If the oven is without a power cable, proceed as follows: 1. Remove the two fixing screws of the terminal block cover located in the bottom part of the oven's back closing panel. 2. Remove the cover to access to the terminal block and insert the power cable (see table) through the opening located on the bottom of the oven. Power cable table No. of wires Type of cable 1N+ ~ H05 RR-F 3 X 1.5 mm² 2+ ~ H05 RR-F 3 X 1.5 mm² (for Switzerland only) 3. Connect the cable to the terminal block, tighten the screws and secure it to the cable fastener. 4. Refit the cover, inserting the two tabs in the special slots, and fix it with the two screws. 14

61002001.book Page 15 Tuesday, March 25, 2008 4:46 PM SAFEGUARDING THE ENVIRONMENT Disposal of packing • The packing material is 100% recyclable and is marked with the recycle symbol . • The various parts of the packing must be disposed of in compliance with local regulations; do not disperse in the environment. Disposal of old electrical appliances • This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. Scrap the appliance in accordance with the local regulations on waste disposal. For further information regarding the treatment, recovery and recycling of this appliance, contact the competent local office, the domestic waste collection service or the shop where you purchased the product. Energy saving • Preheat the oven only if specified in the Product Sheet cooking table or in your recipe. • Use dark, black painted or enamelled baking moulds as they absorb heat very well. IMPORTANT NOTES Important: • Do not allow children or infirm persons to operate the oven without supervision. • Make sure children do not play with the appliance. •The appliance must not be used by children or people (including children) with limited physical, sensory or mental abilities or without experience and knowledge of it, unless instructed in its use by those responsible for their safety. • The accessible parts of the oven may become very hot during use. Keep children away from the appliance. • Do not use abrasive materials or substances to clean the GLASS, as they could damage it. • The appliance becomes very hot during use. Do not touch the heating elements in the oven. • This oven is designed solely for use as a household appliance for cooking food. Other uses are not allowed. The Manufacturer declines any liability for improper use or incorrect setting of the controls. • Any repairs or operations must only be carried out by a qualified technician. • Do not expose the oven to atmospheric agents. • Do not place heavy objects on the door, as they could damage the oven compartment and hinges. Do not cling to the door. • Do not hang anything heavy on the oven door handle. • Do not cover the bottom of the oven with aluminium foil or other objects. • The oven door must close properly. Keep the door seals clean. • Never pour water directly inside the oven when hot. The enamel could become damaged. 15