Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Congratulations on the purchase of your Magnetic<br />
Signs!<br />
Your premium magnetic signs are produced on 0.8mm magnetic<br />
substrate and are designed to be used for vehicles or on metal<br />
A-Frames.<br />
In order to increase the life-span of your magnetic signs and not<br />
harm the paint finish on your vehicle, follow these simple<br />
procedures:-<br />
STORAGE<br />
When not using your magnetic sign, keep it in a clean, dry place.<br />
To avoid cracking or breaking, do not fold or crease.<br />
Storing your magnetic sign flat is recommended. If stored in roll<br />
form, the roll must be a minimum of 85mm in diameter and<br />
lettering on outside of roll to prevent wrinkles.<br />
Avoid placing anything on top of the magnets as this may scratch or<br />
damage the face.<br />
Do not store magnetic signs with the magnetic side facing each<br />
other.<br />
AFFIXING<br />
The vehicle surface and the magnetic side of the sign should be<br />
clean and dry prior to applying.<br />
Before affixing your magnetic sign, be sure all surface paints, clear<br />
coats, and waxes are cured (hardened).<br />
Apply the magnetic sign by making contact with one edge of the<br />
sign to the vehicle surface in the desired location and then let the<br />
adjacent part of the sign contact the surface until the entire sign is<br />
held magnetically.<br />
Make sure the entire magnet is flat against the metal surface and<br />
does not lie over any vehicle trims, etc.<br />
If the magnetic sign is placed in the wrong position, completely<br />
remove from the surface, and reaffix. Do NOT pull the magnet<br />
across the surface, or it may stretch due to the resistance caused<br />
by the high magnetic strength.<br />
Always remove your magnetic sign from your vehicle before going<br />
through a car wash.<br />
Avoid placing your magnetic sign over chrome trim or surface<br />
protrusions of any kind.<br />
Avoid use on horizontal metal surfaces exposed to direct sunlight<br />
(such as automobile hoods).