09.02.2018 Views

Practical Guige to Free Energy Devices

eBook 3000 pages! author: Patrick J. Kelly "This eBook contains most of what I have learned about this subject after researching it for a number of years. I am not trying to sell you anything, nor am I trying to convince you of anything. When I started looking into this subject, there was very little useful information and any that was around was buried deep in incomprehensible patents and documents. My purpose here is to make it easier for you to locate and understand some of the relevant material now available. What you believe is up to yourself and is none of my business. Let me stress that almost all of the devices discussed in the following pages, are devices which I have not personally built and tested. It would take several lifetimes to do that and it would not be in any way a practical option. Consequently, although I believe everything said is fully accurate and correct, you should treat everything as being “hearsay” or opinion. Some time ago, it was commonly believed that the world was flat and rested on the backs of four elephants and that when earthquakes shook the ground, it was the elephants getting restless. If you want to believe that, you are fully at liberty to do so, however, you can count me out as I don’t believe that. " THE MATERIAL PRESENTED IS FOR INFORMATION PURPOSES ONLY. SHOULD YOU DECIDE TO PERFORM EXPERIMENTS OR CONSTRUCT ANY DEVICE, YOU DO SO WHOLLY ON YOUR OWN RESPONSIBILITY -- NEITHER THE COMPANY HOSTING THIS WEB SITE, NOR THE SITE DESIGNER ARE IN ANY WAY RESPONSIBLE FOR YOUR ACTIONS OR ANY RESULTING LOSS OR DAMAGE OF ANY DESCRIPTION, SHOULD ANY OCCUR AS A RESULT OF WHAT YOU DO. ​

eBook 3000 pages!
author: Patrick J. Kelly

"This eBook contains most of what I have learned about this subject after researching it for a number of years. I am not trying to sell you anything, nor am I trying to convince you of anything. When I started looking into this subject, there was very little useful information and any that was around was buried deep in incomprehensible patents and documents. My purpose here is to make it easier for you to locate and understand some of the relevant material now available. What you believe is up to yourself and is none of my business. Let me stress that almost all of the devices discussed in the following pages, are devices which I have not personally built and tested. It would take several lifetimes to do that and it would not be in any way a practical option. Consequently, although I believe everything said is fully accurate and correct, you should treat everything as being “hearsay” or opinion.

Some time ago, it was commonly believed that the world was flat and rested on the backs of four elephants and that when earthquakes shook the ground, it was the elephants getting restless. If you want to believe that, you are fully at liberty to do so, however, you can count me out as I don’t believe that. "

THE MATERIAL PRESENTED IS FOR INFORMATION PURPOSES ONLY. SHOULD YOU DECIDE TO PERFORM EXPERIMENTS OR CONSTRUCT ANY DEVICE, YOU DO SO WHOLLY ON YOUR OWN RESPONSIBILITY -- NEITHER THE COMPANY HOSTING THIS WEB SITE, NOR THE SITE DESIGNER ARE IN ANY WAY RESPONSIBLE FOR YOUR ACTIONS OR ANY RESULTING LOSS OR DAMAGE OF ANY DESCRIPTION, SHOULD ANY OCCUR AS A RESULT OF WHAT YOU DO.

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

and that keeps their operation short when they switch On. The other three transformers 4, 5 and 6 have the<br />

diodes across their primary windings positioned <strong>to</strong> block a positive voltage and so their transis<strong>to</strong>rs remain Off.<br />

When the output voltage of the square-wave genera<strong>to</strong>r goes negative, the situation is reversed and transformers<br />

4, 5 and 6 switch on briefly while transformers 1, 2 and 3 remain Off. The diodes across the primary windings are<br />

1N4148 diodes which have a very fast switching time which can be very important for circuits of this type. The<br />

other diodes are 1N1183 which are rated at 50 volts and 40 amps.<br />

A Three Battery Switching System<br />

Continuing the Tesla Switch style of operation, it is possible <strong>to</strong> get the same effect as the Tesla Switch circuit,<br />

using only three batteries (or three capaci<strong>to</strong>rs). Discussed almost a century ago by Carlos Benitez in his patents,<br />

and more recently described by John Bedini, just three batteries can be used if more complicated circuit switching<br />

is used. Carlos points out that there has <strong>to</strong> be an energy loss due <strong>to</strong> wires heating up and batteries not being<br />

100% efficient. He overcomes these problems with some very clever circuitry which is covered in the following<br />

section. However, it is not at all certain that this is actually the case as experimentation indicates that it is<br />

possible for this kind of battery switching <strong>to</strong> maintain the battery charge levels far beyond the expected.<br />

Here is an untested suggestion for how it might be possible <strong>to</strong> produce a portable, self-powered powerful light.<br />

There are many possible variations on this, and the following description is just intended as an indication of how a<br />

three battery switching system might be constructed. If you are not familiar with simple electronics, then I suggest<br />

that you study the basic electronics tu<strong>to</strong>rial of chapter 12.<br />

Battery charging can be accomplished in various different ways. Obviously, the more the electrical loading can be<br />

reduced, the lesser the need for recharging. Two methods for doing this involve passing the same electrical<br />

current repeatedly through the load, as shown here:<br />

The switching for this arrangement can be implemented in various different ways, but essentially, in Stage 1,<br />

batteries ‘B1’ and ‘B2’ provide twice the voltage of batteries ‘B3 ‘ and ‘B4’, causing current <strong>to</strong> flow through the load<br />

‘L’ and in<strong>to</strong> batteries ‘B3’ and ‘B4’, driven by the voltage difference which is normally, the same as the voltage of<br />

any one of the batteries on its own. Each of the batteries ‘B3’ and ‘B4’ receive only half of the current supplied by<br />

batteries ‘B1’ and ‘B2’, and so, there is, not surprisingly, an energy loss. However, for half of the time, batteries<br />

‘B3’ and ‘B4’ are receiving charging current instead of supplying current <strong>to</strong> the load.<br />

In Stage 2, the batteries are swapped around and the process repeated with batteries ‘B3’ and ‘B4’ supplying<br />

current <strong>to</strong> the load and batteries ‘B1’ and ‘B2’. Tests have shown that with this arrangement, the load ‘L’ can be<br />

powered for longer than if all four batteries were connected in parallel and used <strong>to</strong> supply the load directly. With<br />

this system, each battery receives half of the load current for half of the time.<br />

An alternative method which uses the same principle, but three batteries instead of four, and where each battery<br />

receives all of the load current for one third of the time, is like this:<br />

5 - 11

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!