DW563 DW563KC DW566K DW566KC - Service - DeWalt

ENGLISH• Before replacing the top cover of the mains plugensure that the cable restraint (3) is holding theouter sheath of the cable firmly and that the twoleads are correctly fixed at the terminal screws.Assembly and adjustmentPrior to assembly and adjustment alwaysunplug the tool.DW563/DW563KC - Selecting the operatingmode (fig. B)The Rotary Hammer Drill can be used in twooperating modes:Never use a light socket.Never connect the live (L) or neutral (N)wires to the earth pin marked E or .For 115 V units with a power rating exceeding 1500W, we recommend to fit a plug to BS4343 standard.Using an extension cableIf an extension cable is required, use an approvedextension cable suitable for the power input of thistool (see technical data). The minimum conductor sizeis 1.5 mm 2 . When using a cable reel, always unwindthe cable completely. Also refer to the table below.Rotary drilling:for screwdriving, drilling into steel, woodand plasticsHammer drilling:simultaneous rotating and impacting forconcrete and masonry drillingDW566K/DW566KC - Selecting the operatingmode (fig. B)The Rotary Hammer Drill can be used in threeoperating modes:Rotary drilling:for screwdriving, drilling into steel, woodand plasticsConductor size (mm 2 ) Cable rating (Amperes)0.75 61.00 101.50 152.50 204.00 25Cable length (m)7.5 15 25 30 45 60Voltage Amperes Cable rating (Amperes)115 0 - 2.0 6 6 6 6 6 102.1 - 3.4 6 6 6 6 15 153.5 - 5.0 6 6 10 15 20 205.1 - 7.0 10 10 15 20 20 257.1 - 12.0 15 15 20 25 25 -12.1 - 20.0 20 20 25 - - -230 0 - 2.0 6 6 6 6 6 62.1 - 3.4 6 6 6 6 6 63.5 - 5.0 6 6 6 6 10 155.1 - 7.0 10 10 10 10 15 157.1 - 12.0 15 15 15 15 20 2012.1 - 20.0 20 20 20 20 25 -Hammer drilling:simultaneous rotating and impacting forconcrete and masonry drillingHammering only with spindle lock:impacting only - for light chipping,chiselling and demolition applications.• Select the required operating mode by rotatingthe mode selector (4) towards the symbol on thegear housing.• For screwdriving, refer to section “Instructions foruse”.Inserting and removing SDS-plus ® accessories(fig. C)Your Rotary Hammer Drill uses SDS-plus ®accessories (refer to the inset in fig. C for a crosssectionof an SDS-plus ® bit shank).• Clean and grease the bit shank.• Insert the bit shank into the tool holder (8).17en - 4