manual GSR 10,8 V-Li_773_v3.indd

22 | en Operating instructions
33 Switch off the power tool immediately when
the tool insert jams. Be prepared for high
reaction torque that can cause kickback.
The tool insert jams when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
33 Hold the machine only by the insulated gripping
surfaces, when performing an operation
where the cutting tool may run into
hidden wiring. Contact with a “live” wire will
make exposed metal parts of the tool “live”
and shock the operator.
33 Hold the machine with a firm grip. High
reaction torque can briefly occur while driving
in and loosening screws.
33 Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
33 Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
33 Take protective measures when dust can
develop during working that is harmful to
one’s health, combustible or explosive.
Example: Some dusts are regarded as carcinogenic.
Wear a dust mask and work with
dust/chip extraction when connectable.
33 Keep your workplace clean. Blends of materials
are particularly dangerous. Dust from
light alloys can burn or explode.
33 Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
33 Avoid unintentional switching on. Ensure the
On/Off switch is in the off position before
inserting battery pack. Carrying the power
tool with your finger on the On/Off switch or
inserting the battery pack into power tools
that have the switch on invites accidents.
33 Do not open the battery. Danger of shortcircuiting.
Protect the battery against heat, e.
g., also against continuous sun
irradiation and fire. There is danger
of explosion.
33 In case of damage and improper use of the
battery, vapours may be emitted. Provide
for fresh air and seek medical help in case
of complaints. The vapours can irritate the
respiratory system.
33 When the battery is defective, liquid can
escape and come into contact with adjacent
components. Check any parts concerned.
Clean such parts or replace them, if required.
Functional Description
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The power tool is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Screwdriver bit*
2 Tool holder
3 Locking sleeve
4 Torque presetting ring
5 Soft grip
6 Rotational direction switch
7 On/Off switch
8 Battery unlocking button
9 Battery*
10 LED
11 Drill bit with hexagon shank*
12 Utility clip*
13 Craftsman case*
*The accessories illustrated or described are not
included as standard delivery.
F 000 622 256 | 03.2008
Robert Bosch Ltda.
manual GSR 10,8 V-Li_773_v3.indd 22 05.03.08 09:03:49