plomyFIT catalogue - Plomyplas

TE HEMBRA / TEE WITH FEMALE THREAD /Rosca inserto metálico / Brass insert /B 4370006 21 60112REF. A B18435230211728 INAK1161612 16-1/2”-16 15 180 PCS8435230211735 INAK1162012 20-1/2”-20 10 120 PCS3,93 €4,93 €COLECTOR EN PPA / PLUMBING MANIFOLD /B 4370006 21 60112REF. A B18435230212367 AK34161616 3/4”M 161616 1 50 PCS8435230212374 AK34201616 3/4”M 201616 1 40 PCS8435230212381 AK3416161616 3/4”M 16161616 1 35 PCS8435230212398 AK3420161616 3/4”M 20161616 1 30 PCS6,76 €7,35 €8,74 €9,33 €ADVERTENCIAS- Temperatura Máxima de Trabajo 70 ºC.- La rosca plomyFIT es recta tipo “ROSCA GAS”.- La profundidad de la rosca hembra es de 14mm.- En caso de usar sellador químico, consultar tablade compatibilidades del Manual Técnico oconsultar al Departamento Técnico.- Es OBLIGATORIO biselar el tubo para usar conel accesorio plomyFIT.- Es OBLIGATORIO utilizar los biseladores IPS,consultar tabla de compatibilidades en página5, en función del tubo a instalar.- Consultar apartado de VÁLVULAS en página 47.WARNING- Maximum working temperature 70 ºC.- plomyCLICK threaded fittings are BSP type (alsocalled “GAS THREAD” or “STRAIGHT THREAD”.- Threaded sections depth (length) is 14mm.- Should a chemical sealant is to be used, please,check the compatibility charts included in therespective Technical Manual or contact themanufacturer’s technical department.- Pipe ends MUST always be bevelled prior beinginserted into any plomyFIT fitting.- ONLY the manufacturer own bevelling tools areapproved (please see compatibility chart on page5 of this document).- For further information on the range of compatiblevalves, please, check page 47 of this document.26