Function Module Manual Funktionsmodule Manual ... - Spektrum

EN
2. Carefully remove the Function module and lay it aside.
3. Ensure no wires are kinked or will be pinched when the
function module is installed. With the transmitter power
“OFF”, carefully install the desired Function module switch
configuration, ensuring the plug aligns with the pins inside
the transmitter. Reassemble the DX10t; ensure the screws
are properly fastened to the Function Module. Once the
Function modules are installed, it is safe to power the
transmitter “ON”. There is no additional programming
needed. Spektrum AirWare software automatically
detects the switch configurations when they are installed.
CAUTION: Ensure the DX10t transmitter is
Powered “OFF” before installing Function Modules.
Plugging in the Function modules while the transmitter is
powered on can damage the transmitter.
1-Year Limited Warranty
What this Warranty Covers: Horizon Hobby, Inc.,
(Horizon) warrants to the original purchaser that the product
purchased (the “Product”) will be free from defects in materials
and workmanship for a period of 1 years from the date of
purchase.
What is Not Covered: This warranty is not transferable and
does not cover (i) cosmetic damage, (ii) damage due to acts
of God, accident, misuse, abuse, negligence, commercial
use, or due to improper use, installation, operation or maintenance,
(iii) modification of or to any part of the Product,
(iv) attempted service by anyone other than a Horizon Hobby
authorized service center, or (v) Products not purchased from
an authorized Horizon dealer.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON
MAKES NO OTHER WARRANTY OR REPRESENTATION,
4