sfh 3363 fanlı ısıtıcı kullanma kılavuzu - Sinbo

ENGLISH
SINBO SFH 3363 PTC HEATER
INSTRUCTION MANUAL
* PTC heater Usage Guidance
* Please read this guidance carefully before using your PTC heater, so that you can use it correctly.
* Please keep well with this guidance.
Brief Introduction of the product:
The PTC heater of these series adopts heating technology of resistance wire, it has a high heating
efficiency, centralized heat and extensive usage. The model has the function of swinging.
NAME OF THE COMPONENTS:
1. Power Switch
2. Front Cover
3. Back Cover
4. Mesh Cover
5. Thermostat Knob
6. Oscillation Button
7. Indicator
8. Heating Element
9. Base
1
2
3
4
5
6
7
8
9
TECHNICAL PARAMETERS:
Model: SFH 3363
Rated Power: 1800W
Rated Voltage: 230V~
Frequency: 50Hz
USAGE:
1. Please check before you use:
A: The heating wire and electric wire can not be broken.
B: Please do not use the socket lower than 10A for fear of any accident.
2. There is power & turbo knob. There are 3 selections.
“ ” is Turbo working. , at the same time the indicator is red, the PTC heater is start working. “I” is
900W and Turbo working. “II” is 1800W and Turbo working., “0” is no power
3. When using it ,you can adjust the thermostat knob deasil to the right position and the temperature
will rise higher and higher.
4. For the PTC heater with oscillation button, there is a independent switch for this function.
5. If you stop using PTC heater, turn the two power switch to the original position, then put off the plug.
6. If you want to move the PTC heater , please turn off the power switch, then put off the plug, and hand
on the handle on the back of the PTC heater.
NOTES:
1. You must use 230V/10A or above AC plug-in and safety protection switch.
2. You mustn’t use it near the incendive objects.
3. Strictly prohibit to be covered by anything for fear of that the machine will be over-heating.
- 5 -