Toyota Toyota Parking Aid 800 - PZ464-00425-40 - Toyota Parking Aid 800 - mode d'emploi
Toyota Toyota Parking Aid 800 - PZ464-00425-40 - Toyota Parking Aid 800 - mode d'emploi
Toyota Toyota Parking Aid 800 - PZ464-00425-40 - Toyota Parking Aid 800 - mode d'emploi
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Switching off rear sensors<br />
(Only if optional cancellation switch is installed)<br />
In case of using a trailer, the cancellation switch (optional) has to be turned “OFF” to avoid<br />
continuous detection of the trailer during reverse.<br />
The cancellation switch (optional) is installed in the trunk of the vehicle.<br />
CAUTION<br />
Always approach an obstacle slowly (at less than 5 km/h) and be ready to press the<br />
brake pedal quickly.<br />
CAUTION<br />
When the signal changes from intermittent beeps to a continuous beep, stop the<br />
vehicle immediately.<br />
CAUTION<br />
If the sensors are already too close to an object, they may not be able to detect it.<br />
D. PRECAUTIONS<br />
– Do not allow the sensor to be subjected to impact.<br />
– Do not use a powerful jet spray on the sensors.<br />
E. TROUBLESHOOTING<br />
The flow chart shown on the following page will assist you in determining whether or not<br />
a malfunction is in fact a system error. If the system still fails to operate after you have<br />
carried out the instructions in the flow chart, please contact your installer (*) .<br />
(*) "Installer" means authorized <strong>Toyota</strong> dealer or repair agent or other appropriately qualified and equipped expert.<br />
GB<br />
<strong>Toyota</strong> <strong>Parking</strong> <strong>Aid</strong> <strong>800</strong> 9