Toyota Toyota Parking Aid 800 - PZ464-00425-40 - Toyota Parking Aid 800 - mode d'emploi

1. The sensor is not working even though an obstacle is present
Front Sensors
Is the ignition switch “ON”?
YES
Is the green LED on the dashboard
switched “ON”?
YES
Please consult your installer (*) .
NO
NO
Turn “ON” the ignition switch.
Switch “ON” front sensors as described
in “C. Operation Procedure”.
Rear Sensors
Is the ignition switch “ON”?
YES
Is the shift lever still in "R" (reverse)?
YES
Is the cancellation switch (optional)
“ON”?
YES
Please consult your installer (*) .
NO
NO
NO
Turn “ON” the ignition switch.
Shift the lever to the "R" (reverse)
position.
Turn the cancellation switch (optional)
to “ON” mode.
2. The beeper is constantly ON or is emitting a continual fast
intermittent beep
Is the vehicle pulling a trailer?
NO
Is there any debris, mud, snow, ice, dirt,
etc. on the sensing portion of the
sensor?
NO
Are there any obstacles nearby?
NO
Please consult your installer (*) .
YES
YES
YES
Turn the cancellation switch (optional)
to “OFF” mode.
Remove the debris.
Remove the obstacle or move the
vehicle.
3. The beeper is emitting a continual intermittent tone with
long beeps and short pauses
There is a problem with the connection of the sensors. Please contact your installer (*) .
(*) "Installer" means authorized Toyota dealer or repair agent or other appropriately qualified and equipped expert.
10 Toyota Parking Aid 800 GB