Philips Lisseur - Mode d’emploi - ZHS
Philips Lisseur - Mode d’emploi - ZHS
Philips Lisseur - Mode d’emploi - ZHS
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
10<br />
ENGLISH<br />
Never leave the appliance unattended when it is plugged in. Never<br />
put the appliance on a surface that is not heat-resistant when it is<br />
heating up and when it is hot.<br />
4 When the pilot light turns green, you can adjust the heat setting<br />
to your preference (fig. 2).<br />
- Press the + button to increase the heat setting or press the -<br />
button to decrease the heat setting.The display tells you which heat<br />
setting you have selected.The pilot light turns red to indicate that<br />
the appliance is adjusting the setting.<br />
- The pilot light turns green when the selected heat setting has been<br />
reached.<br />
5 Comb or brush your hair so that it is disentangled and smooth<br />
(fig. 3).<br />
Use a comb to divide the hair into sections. Do not put too much hair<br />
in one section.<br />
B Tip: it is better to section off the crown area and to straighten the hair<br />
underneath first, followed by the top area.<br />
6 Take a section that is not wider than 5 cm. Place it between the<br />
straightening plates and press the handles of the appliance firmly<br />
together.<br />
7 Slide the straightener down the length of the hair in a few<br />
seconds, from root to hair end, without stopping to prevent<br />
overheat settinging (fig. 4).<br />
8 Repeat this process after 20 seconds until you have achieved the<br />
desired look.<br />
9 Allow your hair to cool down. Do not comb or brush it before it<br />
has cooled down, as this would ruin the hairstyle you have just<br />
created.